2007-2013 Highlander Kluger · Service Manual HEATER & AIR CONDITIONING SYSTEM

Heater Control Panel Power Source Circuit

Circuit diagnosis · Vehicles built from May 2007

DESCRIPTION

Battery voltage is supplied to the heater control panel (A/C control assembly) through the A/C No. 2 fuse.

WIRING DIAGRAM

E154319E02

INSPECTION PROCEDURE


1. CHECK HARNESS AND CONNECTOR (IG+ - BODY GROUND)

  1. E152690E15
    Disconnect the connector from the heater control panel.

  1. Measure the voltage according to the value(s) in the table below.

    Standard voltage:
    Tester Connection
    Condition
    Specified Condition
    E8-2 (IG+) - Body ground
    Ignition switch on (IG)
    11 to 14 V
    E8-2 (IG+) - Body ground
    Ignition switch off
    Below 1 V

    Result:
    Result
    Proceed to
    OK
    A
    NG (without Smart entry and start system)
    B
    NG (with Smart entry and start system)
    C



B
GO TO STARTING SYSTEM

C
GO TO PUSH BUTTON START SYSTEM
A


2. CHECK HARNESS AND CONNECTOR (GND - BODY GROUND)

  1. E152690E16
    Measure the resistance according to the value(s) in the table below.

    Standard resistance:
    Tester Connection
    Condition
    Specified Condition
    E8-10 (GND) - Body ground
    Always
    Below 1 Ω



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK

PROCEED TO NEXT CIRCUIT INSPECTION SHOWN IN PROBLEM SYMPTOMS TABLE


← Blower Motor Circuit (from Jul 2010)Air Conditioning Compressor Magnetic Clutch Circuit (May 2007 – Jul 2008) →