REMOVAL
Removal / installation · Vehicles built Aug 2008 – Jun 2010
Versions by build date: May 2007 – Jul 2008 Aug 2008 – Jun 2010 from Jul 2010
- CAUTION:
- Be sure to read Precaution thoroughly before servicing (Click here).
- If the side airbag has deployed, replace the front seat assembly with a new one.
| 1.
DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL |
 |
- CAUTION:
- Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.
- NOTICE:
- When disconnecting the cable, some systems need to be initialized after the cable is reconnected (Click here).
| 2.
REMOVE FRONT SEAT ASSEMBLY |
 |
for Manual Seat: (Click here)for Power Seat: (Click here)
| 3.
SEPARATE AIRBAG WIRE HARNESS (for Manual Seat) |
 |
- Disengage the 2 hooks.
- Disengage the claw and 4 clamps.
| 4.
SEPARATE AIRBAG WIRE HARNESS (for Power Seat) |
 |
- Disengage the 2 hooks.
- Disengage the claw and 4 clamps.
| 5.
REMOVE FRONT SEATBACK COVER WITH PAD |
 |
w/ Seat Heater:
- Disconnect the connector.
Disengage the 2 clamps.
- Remove the 3 hog rings.
- Open the 2 fasteners.
- Remove the 2 hog rings.
- Disengage the 2 hooks.
- Turn back the separate type front seatback cover.
Remove the nut and disengage the hook to separate the separate type front seatback cover bracket.
- Disengage the 4 claws and remove the 2 front seat headrest supports.
Remove the front seatback cover with pad from the front seat frame assembly with adjuster.
| 6.
REMOVE FRONT SEAT AIRBAG ASSEMBLY |
 |
- Disengage the 2 clamps and separate the airbag wire harness.
Remove the 2 nuts and front seat airbag assembly.
- CAUTION:
- The nuts must not be reused.
- Make sure that the seat frame assembly is not deformed. If it is, replace it with a new one.