INSPECTION
Inspection · Vehicles built from May 2007
| INSPECT GENERATOR CLUTCH PULLEY |
Hold the center of the pulley, and confirm that the outer ring turns counterclockwise and does not turn clockwise.

If the result is not as specified, replace the clutch pulley.
| INSPECT GENERATOR DRIVE END FRAME BEARING |
Check that the bearing is not rough or worn.

- OK:
- The bearing rotates smoothly.
| INSPECT GENERATOR BRUSH HOLDER ASSEMBLY |
Using vernier calipers, measure the length of the exposed brushes.

- Standard exposed length:
- 9.5 to 11.5 mm (0.374 to 0.453 in.)
- Minimum exposed length:
- 4.5 mm (0.177 in.)
| INSPECT GENERATOR ROTOR ASSEMBLY |
Check that the generator rotor bearing is not rough or worn.

If necessary, replace the generator rotor assembly.
Check the generator rotor for an open circuit.

Using an ohmmeter, measure the resistance between the slip rings.
- Standard resistance:
- w/o Rear heater assembly and multi-information display:
Condition
Specified Condition
Approx. 20°C (68°F)
2.3 to 2.7 Ω (130 A type)
- w/ Rear heater assembly or multi-information display:
Condition
Specified Condition
Approx. 20°C (68°F)
1.5 to 1.9 Ω (150 A type)
Check the rotor for a short to ground.

Using an ohmmeter, measure the resistance between the slip ring and rotor.
- Standard resistance:
Tester Condition
Specified Condition
Slip ring - Rotor
1 MΩ or higher
Using vernier calipers, measure the slip ring diameter.

- Standard diameter:
- 14.2 to 14.4 mm (0.559 to 0.567 in.)
- Minimum diameter:
- 14.0 mm (0.551 in.)
