2007-2013 Highlander Kluger · Service Manual ENGINE

REPLACEMENT

Removal / installation · Vehicles built from May 2007


1. REPLACE GENERATOR DRIVE END FRAME BEARING

  1. A128076
    Remove the 4 screws and retainer plate from the drive end frame.

  1. A128077E01
    Using SST and a hammer, tap out the drive end frame bearing from the drive end frame.
    SST
    09950-60010   (09951-00250)
    09950-70010   (09951-07100)

  1. A128081E01
    Using SST and a press, press in a new generator drive end frame bearing.
    SST
    09950-60010   (09951-00470)
    09950-70010   (09951-07100)

  1. A137712E01
    Fit the tabs on the retainer plate into the cutouts on the drive end frame to install the retainer plate.

  1. Install the 4 screws.

    Torque:
    2.3 N*m{ 23 kgf*cm , 20 in.*lbf }

← INSPECTION (from May 2007)REASSEMBLY (from May 2007) →