2007-2013 Highlander Kluger · Service Manual ENGINE

REASSEMBLY

Removal / installation · Vehicles built from May 2007


1. INSTALL GENERATOR ROTOR ASSEMBLY
  1. Place the drive end frame on the clutch pulley.

  1. A118367E01
    Install the generator rotor assembly to the drive end frame.

  1. A118365E01
    Place a new generator washer on the generator rotor.


2. INSTALL GENERATOR COIL ASSEMBLY

  1. A172926E01
    Using a deep socket wrench (21 mm) and a press, slowly press in the generator coil assembly.

  1. A128074
    Install the 4 bolts.

    Torque:
    5.8 N*m{ 60 kgf*cm , 52 in.*lbf }


3. INSTALL GENERATOR BRUSH HOLDER ASSEMBLY

  1. A079315E13
    While pushing the 2 brushes into the generator brush holder assembly, insert a φ1.0 mm (0.039 in.) pin into the brush holder hole.

  1. A079316E04
    Install the brush holder assembly to the generator coil with the 2 screws.

    Torque:
    1.8 N*m{ 18 kgf*cm , 16 in.*lbf }

  1. Pull out the pin from the generator brush holder.


4. INSTALL GENERATOR TERMINAL INSULATOR

  1. A128083E01
    Install the terminal insulator to the generator coil.

    NOTICE:
    Pay attention to the installation direction of the terminal insulator.


5. INSTALL GENERATOR REAR END COVER

  1. A128071
    Install the generator rear end cover to the generator coil with the 3 nuts.

    Torque:
    4.6 N*m{ 47 kgf*cm , 41 in.*lbf }


6. INSTALL GENERATOR CLUTCH PULLEY
  1. Temporarily install the clutch pulley onto the rotor shaft.

  1. A128084E01
    Set SST (A) and (B).
    SST
    09820-63020  

  1. A160961E01
    Clamp SST (A) in a vise.

    NOTICE:
    Be sure to fix the flat surface of SST (A) in a vise.

  1. A135194E01
    Place the rotor shaft end into SST (A).

  1. A135195E01
    Fit SST (B) to the clutch pulley.

  1. A151433E01
    Tighten the pulley by turning SST (B) in the direction shown in the illustration.

    Torque:
    w/o SST:
    110 N*m{ 1125 kgf*cm , 81 ft.*lbf }
    w/ SST:
    84 N*m{ 857 kgf*cm , 62 ft.*lbf }

    NOTICE:
    1. Use a torque wrench with a fulcrum length of 318 mm (12.52 in.).
    2. This torque value is effective when SST is parallel to a torque wrench.
    3. Hold the generator assembly tightly.

  1. Remove the generator assembly from SST.

  1. Check that the clutch pulley rotates smoothly.

  1. Install a new clutch pulley cap to the clutch pulley.

← REPLACEMENT (from May 2007)INSTALLATION (May 2007 – Jul 2008) →