2007-2013 Highlander Kluger · Service Manual HEATER & AIR CONDITIONING SYSTEM

DISASSEMBLY

Removal / installation · Vehicles built from Jul 2010

Versions by build date: May 2007 – Jun 2010 from Jul 2010


1. REMOVE MAGNETIC CLUTCH ASSEMBLY

  1. E212992E01
    Place the compressor and magnetic clutch in a vise.
    Text in Illustration 
    *1
    SST
    SST
    09985-00270  

  1. Using SST, hold the magnetic clutch hub.

  1. Remove the bolt, magnetic clutch hub, and magnetic clutch washers.

    HINT:
    There is no set number of magnetic clutch washers because they are used for adjustment.

  1. E212993
    Using a snap ring expander, remove the snap ring and then remove the magnetic clutch rotor.

    NOTICE:
    Take care not to damage the seal cover of the bearing when removing the snap ring.

  1. E212994
    Disconnect the connector.

  1. Disengage the clamp.

  1. Remove the screw and the bracket.

  1. E212995
    Using a snap ring expander, remove the snap ring and magnetic clutch stator.

← DISASSEMBLY (May 2007 – Jun 2010)INSPECTION (May 2007 – Jun 2010) →