2007-2013 Highlander Kluger · Service Manual HEATER & AIR CONDITIONING SYSTEM

INSPECTION

Inspection · Vehicles built May 2007 – Jun 2010

Versions by build date: May 2007 – Jun 2010 from Jul 2010


INSPECT COMPRESSOR AND MAGNETIC CLUTCH (A/C LOCK SENSOR)

  1. E152688E06
    Measure the resistance according to the value(s) in the table below.

    Standard resistance:
    Tester Connection
    Condition
    Specified Condition
    B44-2 (SSR+) - B44-5 (SSR-)
    20°C (68°F)
    160 to 320 Ω

    If the resistance is not as specified, replace the compressor and magnetic clutch.


INSPECT COMPRESSOR AND MAGNETIC CLUTCH (A/C COMPRESSOR SOLENOID)

  1. E152688E07
    Measure the resistance according to the value(s) in the table below.

    Standard resistance:
    Tester Connection
    Condition
    Specified Condition
    B44-3 (SOL+) - B44-6 (SOL-)
    25°C (77°F)
    10.1 to 11.1 Ω

    If the resistance is not as specified, replace the compressor and magnetic clutch.


INSPECT COMPRESSOR AND MAGNETIC CLUTCH

  1. E152688E08
    Disconnect the connector from the magnetic clutch.

  1. Measure the resistance according to the value(s) in the table below.

    Standard resistance:
    Tester Connection
    Condition
    Specified Condition
    B44-1 (MG+) - Body Ground
    Always
    Below 1 Ω

    If the resistance is not as specified, replace the compressor and magnetic clutch.

← DISASSEMBLY (from Jul 2010)INSPECTION (from Jul 2010) →