2007-2013 Highlander Kluger · Service Manual SECURITIES

Engine Hood Courtesy Switch Circuit

Circuit diagnosis · Vehicles built from Jul 2010

Versions by build date: May 2007 – Jul 2008 Aug 2008 – Jun 2010 from Jul 2010

DESCRIPTION

The engine hood courtesy switch is installed together with the hood lock. This switch turns off when the engine hood is opened and turns on when the engine hood is closed.

WIRING DIAGRAM

B148196E07

INSPECTION PROCEDURE


1. READ VALUE USING INTELLIGENT TESTER
  1. Connect the intelligent tester to the DLC3.

  1. Turn the ignition switch to the ON position.

  1. Turn the intelligent tester main switch on.

  1. Select the item below in the Data List and read the display on the tester.

    Main Body: 
    Tester Display
    Measurement Item/Range
    Normal Condition
    Diagnostic Note
    Hood Courtesy Switch
    Engine hood courtesy switch signal / ON or OFF
    ON: Engine hood is CLOSED
    OFF: Engine hood is OPEN
    -

    OK:
    The indicator on the intelligent tester switches between ON and OFF in accordance with the engine hood courtesy switch status.



NG
Go to step 2
OK

PROCEED TO NEXT CIRCUIT INSPECTION SHOWN IN PROBLEM SYMPTOMS TABLE (Click here)

2. INSPECT ENGINE HOOD COURTESY SWITCH

  1. for LHDB154237E01

    1. Disconnect the A8 courtesy switch connector.

    2. Measure the resistance according to the value(s) in the table below.

      Standard resistance:
      Tester Connection
      Switch Condition
      Specified Condition
      1 - 2
      LOCK position
      Below 1 Ω
      UNLOCK position
      10 kΩ or higher

  1. for RHDB154251E01

    1. Disconnect the A8 courtesy switch connector.

    2. Measure the resistance according to the value(s) in the table below.

      Standard resistance:
      Tester Connection
      Switch Condition
      Specified Condition
      1 - 2
      LOCK position
      Below 1 Ω
      UNLOCK position
      10 kΩ or higher



NG
REPLACE HOOD LOCK ASSEMBLY (Click here)
OK


3. CHECK HARNESS AND CONNECTOR (ENGINE HOOD COURTESY SWITCH - BODY GROUND)

  1. B125091E02
    Measure the resistance according to the value(s) in the table below.

    Standard resistance:
    Tester Connection
    Condition
    Specified Condition
    A8-2 - Body ground
    Always
    Below 1 Ω



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK


4. CHECK HARNESS AND CONNECTOR (MAIN BODY ECU - ENGINE HOOD COURTESY SWITCH)

  1. B154238E02
    Disconnect the D7 ECU connector.

  1. Measure the resistance according to the value(s) in the table below.

    Standard resistance:
    Tester Connection
    Condition
    Specified Condition
    D7-16 (HCTY) - A8-1
    Always
    Below 1 Ω
    D7-16 (HCTY) - Body ground
    Always
    10 kΩ or higher



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK

REPLACE MAIN BODY ECU (INSTRUMENT PANEL JUNCTION BLOCK)


← Engine Hood Courtesy Switch Circuit (Aug 2008 – Jun 2010)Horn Circuit (May 2007 – Jul 2008) →