2007-2013 Highlander Kluger · Service Manual SECURITIES

Horn Circuit

Circuit diagnosis · Vehicles built May 2007 – Jul 2008

Versions by build date: May 2007 – Jul 2008 Aug 2008 – Jun 2010 from Jul 2010

DESCRIPTION

When the theft deterrent system is switched from the armed state to the alarm sounding state, the main body ECU transmits a signal to cause the horn to sound at 0.4 second intervals.

WIRING DIAGRAM

B154239E03

INSPECTION PROCEDURE


1. INSPECT HORNS
  1. Press the horn switch and check if the horns sound.

    Result:
    Result
    Proceed to
    Horns sound
    A
    Horns do not sound
    B



B
GO TO HORN SYSTEM (Click here)
A


2. PERFORM ACTIVE TEST USING INTELLIGENT TESTER
  1. Connect the intelligent tester to the DLC3.

  1. Turn the ignition switch to the ON position.

  1. Turn the intelligent tester main switch on.

  1. Select the item below in the Active Test and then check that the horns operate.

    Main Body: 
    Tester Display
    Test Part
    Control Range
    Diagnostic Note
    Vehicle Horn
    Vehicle horns
    ON / OFF
    -

    OK:
    The vehicle horns sound and stop correctly when operating them through the intelligent tester.



NG
Go to step 3
OK

PROCEED TO NEXT CIRCUIT INSPECTION SHOWN IN PROBLEM SYMPTOMS TABLE (Click here)

3. CHECK HARNESS AND CONNECTOR (INSTRUMENT PANEL JUNCTION BLOCK - ENGINE ROOM JUNCTION BLOCK)

  1. Disconnect the ID instrument panel junction block connector and 2D engine room junction block connector.B154240E03

  1. Measure the resistance according to the value(s) in the table below.

    Standard resistance:
    Tester Connection
    Condition
    Specified Condition
    1D-11 - 2D-10
    Always
    Below 1 Ω
    1D-11 - Body ground
    Always
    10 kΩ or higher



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK

REPLACE MAIN BODY ECU (INSTRUMENT PANEL JUNCTION BLOCK)


← Engine Hood Courtesy Switch Circuit (from Jul 2010)Horn Circuit (Aug 2008 – Jun 2010) →