2007-2013 Highlander Kluger · Service Manual SECURITIES

Security Indicator Light Circuit

Circuit diagnosis · Vehicles built Aug 2008 – Jun 2010

Versions by build date: May 2007 – Jul 2008 Aug 2008 – Jun 2010 from Jul 2010

DESCRIPTION

Even when the theft deterrent system is in the disarmed state, the security indicator light blinks due to a signal output from the immobiliser system. The security indicator light blinks continuously due to a continuous signal received from the immobiliser system while in the armed state.
The certification ECU (smart key ECU assembly) causes the security indicator light to come on or blink only during the arming preparation and alarm sounding states.

WIRING DIAGRAM

B154241E06

INSPECTION PROCEDURE


1. PERFORM ACTIVE TEST USING INTELLIGENT TESTER
  1. Connect the intelligent tester to the DLC3.

  1. Turn the engine switch on (IG).

  1. Turn the intelligent tester main switch on.

  1. Select the item below in the Active Test and then check that the indicator operates.

    Entry&Start: 
    Tester Display
    Test Part
    Control Range
    Diagnostic Note
    Security Indicator
    Security indicator light
    ON / OFF
    -

    OK:
    The security indicator light blinks or goes off correctly when operating it through the intelligent tester.



NG
Go to step 2
OK

PROCEED TO NEXT CIRCUIT INSPECTION SHOWN IN PROBLEM SYMPTOMS TABLE (Click here)

2. CHECK HARNESS AND CONNECTOR (SECURITY INDICATOR LIGHT - CERTIFICATION ECU)

  1. B177822E03
    Disconnect the D36 ECU connector.

  1. Disconnect the E13 connector.

  1. Measure the resistance according to the value(s) in the table below.

    Standard resistance:
    Tester Connection
    Condition
    Specified Condition
    D36-2 (IND) - E13-2 (LP)
    Always
    Below 1 Ω
    D36-2 (IND) - Body ground
    Always
    10 kΩ or higher



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK


3. CHECK HARNESS AND CONNECTOR (SECURITY INDICATOR LIGHT - BODY GROUND)

  1. B154243E09
    Measure the resistance according to the value(s) in the table below.

    Standard resistance:
    Tester Connection
    Condition
    Specified Condition
    E13-5 (E) - Body ground
    Always
    Below 1 Ω



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK


4. INSPECT SECURITY INDICATOR LIGHT

  1. B154244E04
    Reconnect the E13 connector with the D36 ECU connector still disconnected.

  1. Apply battery voltage from the wire harness back side between the specified terminals of the indicator, and check the lighting condition of the security indicator light.

    Standard :
    Measurement Condition
    Specified Condition
    Battery positive (+) → Terminal E13-2 (IND+)
    Battery negative (-) → Terminal E13-5 (E)
    Security indicator light comes on

    NOTICE:
    1. If the positive (+) lead and the negative (-) lead are incorrectly connected, the security indicator light will not come on.
    2. Voltage of more than 12 V will damage the security indicator light.
    3. If the voltage is too low, the security indicator light will not come on.



NG
REPLACE SECURITY INDICATOR LIGHT (Click here)
OK

REPLACE CERTIFICATION ECU (SMART KEY ECU ASSEMBLY)


← Security Indicator Light Circuit (May 2007 – Jul 2008)Security Indicator Light Circuit (from Jul 2010) →