2007-2013 Highlander Kluger · Service Manual STEERING

INITIALIZATION

Troubleshooting · Vehicles built from May 2007

HINT:
In vehicles equipped with the smart entry and start system, the starting function may not operate after recharging or while jump-starting a discharged battery. This condition is most common if the battery voltage drops below 9 V. The following procedure has been developed to address this condition.


INITIALIZATION PROCEDURE
C154629E01
  1. Confirm that the SHORT fuse is installed.

    HINT:
    If the SHORT fuse is not installed, install it at this time.

  2. Move the shift lever to the N position.

  3. Turn the engine switch off.

  4. Open the driver's door.

    HINT:
    Opening the driver's door will start an initialization process between the steering lock ECU and the engine room junction block.

  5. Depress the brake pedal.

  6. Press the "START STOP" switch.

← HOW TO PROCEED WITH TROUBLESHOOTING (from Jul 2010)PROBLEM SYMPTOMS TABLE (May 2007 – Jul 2008) →