2007-2013 Highlander Kluger · Service Manual TRANSMISSION

Pattern Select Switch Circuit

Circuit diagnosis · Vehicles built May 2007 – Jun 2010

Versions by build date: May 2007 – Jun 2010 from Jul 2010

DESCRIPTION

ECT SNOW is the system that operates the throttle motor to control engine output to reduce skidding of the driving wheels, guarantee takeoff acceleration, driving straightness and turning stability.

WIRING DIAGRAM

C162877E07

INSPECTION PROCEDURE


1. DRIVING TEST
  1. Start the engine.

  1. Turn the ECT SNOW switch "OFF" (Normal drive mode).

  1. Confirm vehicle response by driving from a parked position to fully depressing the accelerator pedal (*1).

  1. Turn the ECT SNOW switch "ON" and perform the same check as (*1).Confirm that there is a difference between ECT SNOW switch "ON" and "OFF".

    HINT:
    1. Driving test should be done on a paved road (a nonskid road).
    2. Make sure not to use the VSC system when testing a vehicle equipped with one.

    Standard:
    There is a difference in acceleration between "ON" and "OFF".



NG
Go to step 2
OK

PROCEED TO NEXT CIRCUIT INSPECTION SHOWN IN PROBLEM SYMPTOMS TABLE

2. CHECK HARNESS AND CONNECTOR (NO. 1 PATTERN SELECT SWITCH ASSEMBLY - BODY GROUND)

  1. C168600E02
    Disconnect the No. 1 pattern select switch (ECT SNOW switch) connector.

  1. Measure the resistance according to the value(s) in the table below.

    HINT:
    The No. 1 pattern select switch connector has no terminals in locations of 1, 2, 7 and 8.

    Standard resistance:
    Tester Connection
    Condition
    Specified Condition
    3 - Body ground
    Always
    Below 1 Ω



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK


3. INSPECT NO. 1 PATTERN SELECT SWITCH ASSEMBLY

  1. C168601E02
    Measure the resistance according to the value(s) in the table below.

    HINT:
    The No. 1 pattern select switch connector has no terminals in locations of 1, 2, 7 and 8.

    Standard resistance:
    Tester Connection
    Switch Condition
    Specified Condition
    3 - 6
    Press continuously Pattern select switch
    Below 1 Ω
    Release Pattern select switch
    10 kΩ or higher



NG
REPLACE NO. 1 PATTERN SELECT SWITCH ASSEMBLY
OK


4. CHECK HARNESS AND CONNECTOR (NO. 1 PATTERN SELECT SWITCH ASSEMBLY - ECM)

  1. C168527E09
    Connect the No. 1 pattern select switch (ECT SNOW switch) connector.

  1. Disconnect the ECM connector.

  1. Measure the resistance according to the value(s) in the table below when the shift lever is moved to each position.

    Standard resistance:
    Tester Connection
    Switch Condition
    Specified Condition
    D32-27 (SNW1) - Body ground
    Press continuously Pattern select switch
    Below 1 Ω
    Release Pattern select switch
    10 kΩ or higher



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK

PROCEED TO NEXT CIRCUIT INSPECTION SHOWN IN PROBLEM SYMPTOMS TABLE


← Transmission Control Switch Circuit (from Jul 2010)Pattern Select Switch Circuit (from Jul 2010) →