ECT SNOW is the system that operates the throttle motor to control engine output to reduce skidding of the driving wheels, guarantee takeoff acceleration, driving straightness and turning stability.
WIRING DIAGRAM
INSPECTION PROCEDURE
1. DRIVING TEST
Start the engine.
Turn the ECT SNOW switch "OFF" (Normal drive mode).
Confirm vehicle response by driving from a parked position to fully depressing the accelerator pedal (*1).
Turn the ECT SNOW switch "ON" and perform the same check as (*1).Confirm that there is a difference between ECT SNOW switch "ON" and "OFF".
HINT:
Driving test should be done on a paved road (a nonskid road).
Make sure not to use the VSC system when testing a vehicle equipped with one.
Standard:
There is a difference in acceleration between "ON" and "OFF".