2007-2013 Highlander Kluger · Service Manual COMMUNICATION SYSTEM

Power Steering ECU Communication Stop Mode

Circuit diagnosis · Vehicles built from Jul 2010

Versions by build date: May 2007 – Jul 2008 Aug 2008 – Jun 2010 from Jul 2010

DESCRIPTION

Detection Item
Symptom
Trouble Area
Power Steering ECU Communication Stop Mode
  1. EPS is not displayed on "BUS CHECK" screen of intelligent tester
  2. Applies to "POWER STEERING ECU COMMUNICATION STOP MODE" in "DTC COMBINATION TABLE"
  1. Power source circuit of the power steering ECU
  2. Power steering ECU branch wire or connector
  3. Power steering ECU

WIRING DIAGRAM

C152888E05
C170363E01

INSPECTION PROCEDURE

NOTICE:
  1. Turn the ignition switch off before measuring the resistances of the main wire and the branch wire.
  2. After the ignition switch is turned off, check that the key reminder warning system and light reminder warning system are not in operation.
  3. Before measuring the resistance, leave the vehicle for at least 1 minute and do not operate the ignition switch, any other switches or doors. If doors need to be opened in order to check the connectors, open the doors and leave them open.

HINT:
  1. Operating the ignition switch, any other switches, or a door triggers related ECU and sensor communication on the CAN. This communication will cause the resistance value to change.
  2. Even after DTCs are cleared, if a DTC is stored again after driving the vehicle for a while, the malfunction may be occurring due to vibration of the vehicle. In such a case, wiggling the ECUs or wire harness while performing the inspection below will help determine the cause of the malfunction.


1. CHECK CAN BUS WIRE FOR DISCONNECTION (POWER STEERING ECU BRANCH WIRE)
  1. Turn the ignition switch off.

  1. Disconnect the power steering ECU connector.

  1. C128052E11
    Measure the resistance according to the value(s) in the table below.

    Standard resistance:
    Tester Connection
    Condition
    Specified Condition
    D5-2 (CANH) - D5-8 (CANL)
    Ignition switch off
    54 to 69 Ω



NG
REPAIR OR REPLACE CAN BRANCH WIRE OR CONNECTOR (POWER STEERING ECU BRANCH WIRE)
OK


2. CHECK WIRE HARNESS (POWER STEERING ECU - BATTERY AND BODY GROUND)
  1. Disconnect the power steering ECU connectors.

  1. C160514E09
    Measure the resistance according to the value(s) in the table below.

    Standard resistance:
    Tester Connection
    Condition
    Specified Condition
    D4-2 (PGND) - Body ground
    Always
    Below 1 Ω

  1. Measure the voltage according to the value(s) in the table below.

    Standard voltage:
    Tester Connection
    Condition
    Specified Condition
    D4-1 (PIG) - Body ground
    Always
    10 to 14 V
    D5-5 (IG) - Body ground
    Ignition switch on (IG)
    10 to 14 V



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK

REPLACE POWER STEERING ECU (Click here)


← Power Steering ECU Communication Stop Mode (Aug 2008 – Jun 2010)Steering Angle Sensor Communication Stop Mode (May 2007 – Jul 2008) →