2007-2013 Highlander Kluger · Service Manual STEERING

DTC CHECK / CLEAR

Troubleshooting · Vehicles built from May 2007


CHECK DTC
  1. Turn the ignition switch off.

  2. Connect the intelligent tester to the DLC3.

  3. Turn the ignition switch on (IG).

  4. Turn the intelligent tester on.

  5. Read the DTCs by following the prompts on the intelligent tester.

    HINT:
    Refer to the intelligent tester operator's manual for further details.


CLEAR DTC
  1. Turn the ignition switch off.

  2. Connect the intelligent tester to the DLC3.

  3. Turn the ignition switch on (IG).

  4. Turn the intelligent tester on.

  5. Clear the DTCs by following the prompts on the intelligent tester.

    HINT:
    Refer to the intelligent tester operator's manual for further details.

  6. Turn the ignition switch off.

  7. Disconnect the intelligent tester from the DLC3.

← DIAGNOSIS SYSTEM (from Jul 2010)FREEZE FRAME DATA (from May 2007) →