2007-2013 Highlander Kluger · Service Manual TRANSMISSION

ADJUSTMENT

Removal / installation · Vehicles built from May 2007


1. ADJUST SHIFT LEVER POSITION

  1. D025118
    Loosen the nut on the control shaft lever.

  1. D025119
    Push the control shaft fully downward.

  1. Return the control shaft lever 2 notches to the N position.

  1. C168468
    While pushing the control cable end up with the shift lever in the N position, install it to the control shaft lever with the nut.

    Torque:
    12 N*m{ 122 kgf*cm , 9 ft.*lbf }

    NOTICE:
    1. If the control cable end is excessively pushed up, the shift lever cannot be adjusted.
    2. When tightening the nut, confirm that the control cable is properly stretched.

  1. Start the engine and make sure that the vehicle moves forward when shifting the lever from the N to the D position and moves rearward when shifting it to the R position.

← INSPECTION (from May 2007)REASSEMBLY (from May 2007) →