2007-2013 Highlander Kluger · Service Manual TRANSMISSION

REASSEMBLY

Removal / installation · Vehicles built from May 2007


1. INSTALL NO. 2 POSITION INDICATOR SLIDE COVER

  1. C168458
    Install the position indicator slide cover to the No. 2 position indicator slide cover.


2. INSTALL POSITION INDICATOR SLIDE COVER

  1. C169593E01
    Install the position indicator slide cover to the position indicator housing lower.

    NOTICE:
    Install the No. 2 position indicator slide cover with the boss facing the rear of the vehicle.


3. INSTALL POSITION INDICATOR HOUSING LOWER

  1. C168448
    Engage the 4 claws and install the position indicator housing lower to the position indicator housing.

    NOTICE:
    Make sure that the claws are firmly engaged.


4. INSTALL POSITION INDICATOR LIGHT GUIDE

  1. C168456
    Engage the 4 claws and install the position indicator light guide to the position indicator housing lower.

    NOTICE:
    Make sure that the claws are firmly engaged.


5. INSTALL POSITION INDICATOR LIGHT BULB
  1. Install the cap to the bulb.

  1. install the bulb to the position indicator light wire socket.


6. INSTALL INDICATOR LIGHT WIRE SUB-ASSEMBLY

  1. C168452
    Install the indicator light wire sub-assembly to the position indicator light guide.


7. INSTALL POSITION INDICATOR HOUSING ASSEMBLY

  1. C168447
    Engage the 4 claws and install the position indicator housing to the shift lever assembly.

    NOTICE:
    Make sure that the claws are firmly engaged.

  1. Connect the wire harness clamp to the shift lock control unit.

  1. G028933E01
    Connect terminals (4) and (8) of the indicator light wire.

  1. Push the stopper.

  1. C168446
    Connect the connector and 2 wire harness clamps to the shift lock control unit.

← ADJUSTMENT (from May 2007)INSTALLATION (May 2007 – Jul 2008) →