Interior Light Circuit
Circuit diagnosis · Vehicles built May 2007 – Jul 2008
Versions by build date: May 2007 – Jul 2008 Aug 2008 – Jun 2010 from Jul 2010
DESCRIPTION
The illuminated entry system controls the personal light, interior lights and ignition key cylinder light*1.
- HINT:
- *1: w/o Smart Entry and Start System
WIRING DIAGRAM


INSPECTION PROCEDURE
| 1. PERFORM ACTIVE TEST USING INTELLIGENT TESTER |
 |
Connect the intelligent tester to the DLC3.
Turn the ignition switch on (IG).
Turn the intelligent tester on.
Select the following menu items: Body Electrical / Main Body / Active Test.
Check the operation.
Main Body:
Tester Display
|
Test Part
|
Control Range
|
Diagnostic Note
|
Illuminated Entry System
|
Personal light, interior lights and ignition key cylinder light (Light switch is in DOOR position and all doors are closed).
|
ON/OFF
|
-
|
- OK:
- Each light fades in.
|
NG |
 |
|
|
|
| OK |
|
 |
|
| PROCEED TO NEXT CIRCUIT INSPECTION SHOWN IN PROBLEM SYMPTOMS TABLE (Click here)
|
|
| 2. INSPECT FUSE (DOME) |
 |
Remove the DOME fuse from the engine room relay block.
Measure the resistance according to the value(s) in the table below.
- Standard resistance:
Tester Display
|
Condition
|
Specified Condition
|
DOME fuse
|
Always
|
Below 1 Ω
|
|
NG |
 |
|
|
|
| OK |
|
 |
|
| 3. CHECK HARNESS AND CONNECTOR (BATTERY - INSTRUMENT PANEL JUNCTION BLOCK) |
 |
- Disconnect the 1I and 1R instrument panel junction block connectors.
Measure the voltage according to the value(s) in the table below.
- Standard voltage:
Tester Connection
|
Condition
|
Specified Condition
|
1I-10 (ILE) - Body ground
|
Always
|
11 to 14 V
|
1R-5 (ILE) - Body ground
|
Always
|
11 to 14 V
|
|
NG |
 |
|
| REPAIR OR REPLACE HARNESS OR CONNECTOR |
|
|
| OK |
|
 |
|
| REPLACE MAIN BODY ECU (INSTRUMENT PANEL JUNCTION BLOCK) |
|