2007-2013 Highlander Kluger · Service Manual BODY ELECTRICAL

Interior Light Circuit

Circuit diagnosis · Vehicles built from Jul 2010

Versions by build date: May 2007 – Jul 2008 Aug 2008 – Jun 2010 from Jul 2010

DESCRIPTION

The illuminated entry system controls the personal light, interior lights and ignition key cylinder light*1.

HINT:
*1: w/o Smart Entry and Start System


WIRING DIAGRAM

E211846E01

INSPECTION PROCEDURE


1. PERFORM ACTIVE TEST USING INTELLIGENT TESTER
  1. Connect the intelligent tester to the DLC3.

  1. Turn the ignition switch on (IG).

  1. Turn the intelligent tester on.

  1. Select the following menu items: Body Electrical / Main Body / Active Test.

  1. Check the operation.

    Main Body: 
    Tester Display
    Test Part
    Control Range
    Diagnostic Note
    Illuminated Entry System
    Personal light, interior lights and ignition key cylinder light (Light switch is in DOOR position and all doors are closed).
    ON/OFF
    -

    OK:
    Each light fades in.



NG
Go to step 2
OK

PROCEED TO NEXT CIRCUIT INSPECTION SHOWN IN PROBLEM SYMPTOMS TABLE (Click here)

2. INSPECT FUSE (DOME)
  1. Remove the DOME fuse from the engine room relay block.

  1. Measure the resistance according to the value(s) in the table below.

    Standard resistance:
    Tester Display
    Condition
    Specified Condition
    DOME fuse
    Always
    Below 1 Ω



NG
REPLACE FUSE
OK


3. CHECK HARNESS AND CONNECTOR (BATTERY - INSTRUMENT PANEL JUNCTION BLOCK)

  1. E133307E02
    Disconnect the 1I and 1R instrument panel junction block connectors.

  1. Measure the voltage according to the value(s) in the table below.

    Standard voltage:
    Tester Connection
    Condition
    Specified Condition
    1I-10 (ILE) - Body ground
    Always
    11 to 14 V
    1R-5 (ILE) - Body ground
    Always
    11 to 14 V



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK

REPLACE MAIN BODY ECU (INSTRUMENT PANEL JUNCTION BLOCK)


← Interior Light Circuit (Aug 2008 – Jun 2010)Engine Switch Illumination Circuit (May 2007 – Jul 2008) →