2007-2013 Highlander Kluger · Service Manual COMMUNICATION SYSTEM

Skid Control ECU Communication Stop Mode

Circuit diagnosis · Vehicles built May 2007 – Jul 2008

Versions by build date: May 2007 – Jul 2008 Aug 2008 – Jun 2010 from Jul 2010

DESCRIPTION

Detection Item
Symptom
Trouble Area
Skid Control ECU Communication Stop Mode
  1. "ABS/VSC/TRC" is not displayed on "Communication Bus Check" screen of intelligent tester
  2. Applies to "Skid Control ECU Communication Stop Mode" in "DTC COMBINATION TABLE"
  1. Power source circuit of skid control ECU
  2. Skid control ECU branch wire or connector
  3. Skid control ECU

WIRING DIAGRAM

C126207E34

INSPECTION PROCEDURE

NOTICE:
  1. Turn the ignition switch off before measuring the resistances of the CAN main wire and the CAN branch wire.
  2. After the ignition switch is turned off, check that the key reminder warning system and light reminder warning system are not in operation.
  3. Before measuring the resistance, leave the vehicle as is for at least 1 minute and do not operate the ignition switch, any other switches or the doors. If the doors need to be opened in order to check the connectors, open the doors and leave them open.

HINT:
  1. Operating the ignition switch, any other switches, or a door triggers related ECU and sensor communication on the CAN. This communication will cause the resistance value to change.
  2. Even after DTCs are cleared, if a DTC is stored again after driving the vehicle for a while, the malfunction may be occurring due to vibration of the vehicle. In such a case, wiggling the ECUs or wire harness while performing the inspection below will help determine the cause of the malfunction.


1. CHECK CAN BUS WIRE FOR DISCONNECTION (SKID CONTROL ECU BRANCH WIRE)
  1. Turn the ignition switch off.

  1. Disconnect the skid control ECU connector.

  1. C156384E48
    Measure the resistance according to the value(s) in the table below.

    Standard resistance:
    Tester Connection
    Condition
    Specified Condition
    A24-25 (CANH) - A24-14 (CANL)
    Ignition switch off
    54 to 69 Ω



NG
REPAIR OR REPLACE CAN BUS BRANCH WIRE OR CONNECTOR (SKID CONTROL ECU BRANCH WIRE)
OK


2. CHECK HARNESS AND CONNECTOR (IG1, GND1)
  1. Disconnect the skid control ECU connector.

  1. C156384E49
    Measure the resistance according to the value(s) in the table below.

    Standard resistance:
    Tester Connection
    Condition
    Specified Condition
    A24-1 (GND1) - Body ground
    Always
    Below 1 Ω

  1. Measure the voltage according to the value(s) in the table below.

    Standard voltage:
    Tester Connection
    Condition
    Specified Condition
    A24-34 (IG1) - Body ground
    Ignition switch on (IG)
    10 to 14 V



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK


3. CHECK DTC OUTPUT
  1. Check the skid control ECU output DTC (Click here).

  1. Read the DTC.

    OK:
    C1241 is not stored.



NG
GO TO DTC CHART (C1241) (Click here)
OK

REPLACE BRAKE ACTUATOR ASSEMBLY (Click here)


← U1002 (CAN MS BUS) Lost Communication with Gateway Module (Main body ECU) (from Jul 2012)Skid Control ECU Communication Stop Mode (Aug 2008 – Jun 2010) →