INITIALIZATION
Troubleshooting · Vehicles built from May 2007
| INITIALIZE SLIDING ROOF DRIVE GEAR SUB-ASSEMBLY |
- NOTICE:
- Be sure to initialize the sliding roof drive gear (pulse sensor) after adjusting the sliding roof glass position or removing and installing components. Without initialization, there may be a malfunction in the sliding roof auto operation, jam protection operation, or key-off operation.
- If any of the following conditions occurs during initialization procedure, initialization will fail.
- The ignition switch is turned off.
- Communication is cut off.
- Another switch is turned on during initialization.
- Vehicle speed is 5 km/h (3 mph) or more.
- The vehicle experiences a strong vibration during initialization, such as the slamming of a door.
- The ignition switch is turned off.
Initialization
- HINT:
- According to the following chart, proceed to the appropriate initialization procedure.
Sliding Roof Condition
Proceed to
The sliding roof AUTO function does not operate.
[A]
The sliding roof AUTO function
[B]
Although the sliding roof AUTO function operates, the roof glass stops moving or starts moving in the opposite direction while tilting downward.
[B]
Although the sliding roof AUTO function operates, the roof glass stops moving or starts moving in the opposite direction while sliding closed.
[C]
[A] The sliding roof AUTO function does not operate
- Turn the ignition switch on (IG). *1
- Fully close the sliding roof.
- Press and hold the sliding roof switch (TILT UP side) until the following movement finishes: Tilt up → stationary state for at least 1 second → tilt down → slide open → slide close.
- NOTICE:
- Press and hold the sliding roof switch (TILT UP side) until step *2 is complete. If the switch is released before step *2 is complete, restart from step *1.
- Confirm that the roof glass is stopped at the fully closed position and initialization is completed. *2
- Turn the ignition switch on (IG). *1
[B] Although the sliding roof AUTO function operates, the roof glass stops moving or starts moving in the opposite direction while tilting downward.
- Turn the ignition switch on (IG). *1
- Press and hold the sliding roof switch (TILT UP side) until the sliding roof stops.
- After the sliding roof stops, release the switch.
- Press and hold the sliding roof switch (TILT UP side) for more than 10 seconds until the following movement finishes: Tilt up → stationary state for at least 1 second → tilt down → slide open → slide close.
- NOTICE:
- Press and hold the sliding roof switch (TILT UP side) until step *2 is complete. If the switch is released before step *2 is complete, restart from step *1.
- Confirm that the roof glass is stopped at the fully closed position and initialization is complete. *2
- Confirm that the sliding roof can be normally operated with the AUTO function.
- Turn the ignition switch on (IG). *1
[C] Although the sliding roof AUTO function operates, the roof glass stops moving or starts moving in the opposite direction while sliding closed.
- Turn the ignition switch on (IG). *1
- Press and hold sliding roof switch (TILT UP side) until the following movement finishes: Slide close → roof glass stops moving or starts moving in the opposite direction → stationary for at least 10 seconds → slide close.
- NOTICE:
- Press and hold sliding roof switch (TILT UP side) until step *2 is complete. If the switch is released before step *2 is complete, restart from step *1.
- After the sliding roof has stopped at the fully closed position, release the switch. *2
- Follow the initialization procedure described in [A] (The sliding roof AUTO function does not function).
- Turn the ignition switch on (IG). *1