HOW TO PROCEED WITH TROUBLESHOOTING
Troubleshooting · Vehicles built from Jul 2010
Versions by build date: May 2007 – Jul 2008 Aug 2008 – Jun 2010 from Jul 2010
- HINT:
- Use the following procedures to troubleshoot the sliding roof system.
- *: Use the intelligent tester.
| 1.VEHICLE BROUGHT TO WORKSHOP |
| NEXT |
|
 |
|
|
| 2.INSPECT BATTERY VOLTAGE |
- Standard voltage:
- 11 to 14 V
- If the voltage is below 11 V, recharge or replace the battery before proceeding to the next step.
| NEXT |
|
 |
|
|
| 3.INSPECT COMMUNICATION FUNCTION OF MULTIPLEX COMMUNICATION SYSTEM (LIN)* |
Using the intelligent tester, check if the multiplex communication system is functioning normally.
- Result:
Result
|
Proceed to
|
LIN DTC is not output
|
A
|
LIN DTC is output
|
B
|
|
B.
|
 |
|
|
| A |
|
 |
|
|
Delete the DTCs (Click here).
Recheck for DTCs (Click here).
- HINT:
- If DTCs are detected frequently, replace the ECU.
- OK:
- DTC is not output.
|
NG.
|
 |
|
|
| OK |
|
 |
|
|
- Result:
Result
|
Proceed to
|
Fault is not listed in problem symptoms table
|
A
|
Fault is listed in problem symptoms table
|
B
|
|
B.
|
 |
|
|
| A |
|
 |
|
|
| 6.OVERALL ANALYSIS AND TROUBLESHOOTING* |
- Data List / Active Test (Click here)
- Terminals of ECU (Click here)
- On-vehicle Inspection (Click here)
| NEXT |
|
 |
|
|
| 7.ADJUST, REPAIR OR REPLACE |
| NEXT |
|
 |
|
|
| NEXT |
|
 |
|
|