2007-2013 Highlander Kluger · Service Manual BODY ELECTRICAL

Reverse Signal Circuit

Circuit diagnosis · Vehicles built from Jul 2010

Versions by build date: May 2007 – Jul 2008 Aug 2008 – Jun 2010 from Jul 2010

DESCRIPTION

The clock assembly receives a reverse signal from the park/neutral position switch assembly.

WIRING DIAGRAM

E176572E31

INSPECTION PROCEDURE


1. INSPECT CLOCK ASSEMBLY (REVERSE SIGNAL)
  1. Disconnect the E9 clock assembly connector.

  1. Measure the voltage according to the value(s) in the table below.

    Standard Voltage:
    Tester Connection
    Condition
    Specified Condition
    E9-2 (REV) - Body ground
    Ignition switch ON
    Shift lever in R
    11 to 14 V
    E9-2 (REV) - Body ground
    Ignition switch ON
    Shift lever any position except R
    Below 1 V



NG
Go to step 2
OK

PROCEED TO NEXT CIRCUIT INSPECTION SHOWN IN PROBLEM SYMPTOMS TABLE (Click here)

2. CHECK HARNESS AND CONNECTOR (CLOCK ASSEMBLY - PARK/NEUTRAL POSITION SWITCH ASSEMBLY)
  1. Disconnect the E9 clock assembly connector and B5 park/neutral position switch assembly connector.

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    E9-2 (REV) - B5-1 (RL)
    Always
    Below 1 Ω
    E9-2 (REV) - Body ground
    Always
    10 kΩ or higher



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK


3. CHECK HARNESS AND CONNECTOR (PARK/NEUTRAL POSITION SWITCH ASSEMBLY - BATTERY)
  1. Disconnect the B5 park/neutral position switch assembly connector.

  1. Measure the voltage according to the value(s) in the table below.

    Standard Voltage:
    Tester Connection
    Condition
    Specified Condition
    B5-2 (RB) - Body ground
    Ignition switch ON
    11 to 14 V

    1. Proceed to the next step based on the check result.

      Result:
      Result
      Proceed to
      OK (for U151E)
      A
      OK (for U151F)
      B
      NG
      C



B
REPLACE PARK/NEUTRAL POSITION SWITCH ASSEMBLY (for U151F) (Click here)

C
REPAIR OR REPLACE HARNESS OR CONNECTOR
A

REPLACE PARK/NEUTRAL POSITION SWITCH ASSEMBLY (for U151E) (Click here)


← Reverse Signal Circuit (Aug 2008 – Jun 2010)Display Signal Circuit between Clock Assembly and Television Camera Assembly (May 2007 – Jul 2008) →