Display Signal Circuit between Clock Assembly and Television Camera Assembly
Circuit diagnosis · Vehicles built May 2007 – Jul 2008
Versions by build date: May 2007 – Jul 2008 Aug 2008 – Jun 2010 from Jul 2010
DESCRIPTION
This is the display signal circuit of the television camera assembly.WIRING DIAGRAM


INSPECTION PROCEDURE
| 1. CHECK HARNESS AND CONNECTOR (CLOCK ASSEMBLY - TELEVISION CAMERA ASSEMBLY) |
 |
- Disconnect clock assembly connector E9.
- Disconnect television camera assembly connector S1.
Measure the resistance according to the value(s) in the table below.
- Standard resistance:
Tester Connection
|
Condition
|
Specified Condition
|
S1-2 (CV+) - E9-14 (V+)
|
Always
|
Below 1 Ω
|
S1-3 (CGND) - E9-4 (CGND)
|
Always
|
Below 1 Ω
|
S1-4 (CB+) - E9-12 (CA+)
|
Always
|
Below 1 Ω
|
S1-1 (CV-) - E9-15 (V-)
|
Always
|
Below 1 Ω
|
S1-2 (CV+) - Body ground
|
Always
|
10 kΩ or higher
|
S1-3 (CGND) - Body ground
|
Always
|
10 kΩ or higher
|
S1-4 (CB+) - Body ground
|
Always
|
10 kΩ or higher
|
S1-1 (CV-) - Body ground
|
Always
|
10 kΩ or higher
|
|
NG |
 |
|
| REPAIR OR REPLACE HARNESS OR CONNECTOR |
|
|
| OK |
|
 |
|
| 2. INSPECT CLOCK ASSEMBLY |
 |
- Reconnect clock assembly connector E9.
Measure the voltage according to the value(s) in the table below.
- Standard voltage:
Tester Connection
|
Condition
|
Specified Condition
|
E9-12 (CA+) - E9-4 (CGND)
|
Ignition switch on (IG) Shift lever R position
|
Approx. 6 V
|
|
NG |
 |
|
|
|
| OK |
|
 |
|
| 3. INSPECT TELEVISION CAMERA ASSEMBLY |
 |
Reconnect clock assembly connector E9 and television camera assembly connector S1.

Check the waveform of the television camera assembly using an oscilloscope.
- OK:
- Pulses as shown in the illustration.
Item
|
Content
|
Terminal No. (Symbols)
|
S1-2 (CV+) - S1-1 (CV-)
|
Tool
|
0.2 V/DIV., 0.2 μsec./DIV.
|
Condition
|
Ignition switch on (IG), Shift lever R position
|
|
NG |
 |
|
|
|
| OK |
|
 |
|
| PROCEED TO NEXT CIRCUIT INSPECTION SHOWN IN PROBLEM SYMPTOMS TABLE (Click here)
|
|