REMOVAL
Removal / installation · Vehicles built May 2007 – Jul 2008
Versions by build date: May 2007 – Jul 2008 Aug 2008 – Jun 2010 from Jul 2010
| 1.
REMOVE ENGINE UNDER COVER ASSEMBLY
|
 |
- Remove the 2 bolts and engine under cover assembly RR.
- Remove the 2 bolts, 2 screws, 5 clips and engine under cover assembly.
| 2.
REMOVE NO. 1 ENGINE UNDER COVER
|
 |
- Remove the 6 bolts, 2 clips and No. 1 engine under cover.
| 3.
REMOVE NO. 2 ENGINE UNDER COVER
|
 |
- Remove the 2 bolts and No. 2 engine under cover.
| 4.
REMOVE TAIL EXHAUST PIPE ASSEMBLY |
 |
- Remove the 2 bolts and 2 compression springs.
Disconnect the exhaust pipe support and remove the tail exhaust pipe assembly.
Remove the gasket from the center exhaust pipe assembly.
| 5.
REMOVE EXHAUST PIPE DAMPER |
 |
- Remove the 2 bolts and exhaust pipe damper.
| 6.
REMOVE CENTER EXHAUST PIPE ASSEMBLY |
 |
- Remove the 2 bolts and 2 compression springs.
Disconnect the 3 exhaust pipe supports and remove the center exhaust pipe assembly.
Remove the gasket from the No. 3 exhaust pipe sub-assembly.
| 7.
REMOVE FRONT NO. 3 EXHAUST PIPE SUB-ASSEMBLY |
 |
- Remove the 3 clamps and disconnect the heated oxygen sensor (for bank 1 sensor 2) connector.
- Remove the 2 bolts, 2 nuts and front No. 3 exhaust pipe sub-assembly.
Remove the 2 gaskets from the front No. 3 exhaust pipe sub-assembly.
| 8.
REMOVE HEATED OXYGEN SENSOR (for Bank 1 Sensor 2)
|
 |
- Using SST, remove the heated oxygen sensor from the front No. 3 exhaust pipe sub-assembly.
- SST
- 09224-00010
| 9.
REMOVE FRONT EXHAUST PIPE ASSEMBLY |
 |
- Disconnect the heated oxygen sensor (for bank 2 sensor 2) connector.
- Loosen the bolt.
Remove the 2 nuts and front exhaust pipe assembly.
Remove the gasket from the front exhaust pipe assembly.
| 10.
REMOVE HEATED OXYGEN SENSOR (for Bank 2 Sensor 2)
|
 |
- Using SST, remove the heated oxygen sensor from the front exhaust pipe assembly.
- SST
- 09224-00010