2007-2013 Highlander Kluger · Service Manual ENGINE

REMOVAL

Removal / installation · Vehicles built Aug 2008 – Jun 2010

Versions by build date: May 2007 – Jul 2008 Aug 2008 – Jun 2010 from Jul 2010


1. REMOVE ENGINE UNDER COVER ASSEMBLY

  1. A171849
    Remove the 2 bolts and engine under cover assembly RR.

  1. A171850
    Remove the 2 bolts, 2 screws, 5 clips and engine under cover assembly.


2. REMOVE NO. 1 ENGINE UNDER COVER

  1. A171855
    Remove the 6 bolts, 2 clips and No. 1 engine under cover.


3. REMOVE NO. 2 ENGINE UNDER COVER

  1. A171854
    Remove the 2 bolts and No. 2 engine under cover.


4. REMOVE TAIL EXHAUST PIPE ASSEMBLY

  1. A170139
    Remove the 2 bolts and 2 compression springs.

  1. Disconnect the exhaust pipe support and remove the tail exhaust pipe assembly.

  1. Remove the gasket from the center exhaust pipe assembly.


5. REMOVE EXHAUST PIPE DAMPER

  1. A174261
    Remove the 2 bolts and exhaust pipe damper.


6. REMOVE CENTER EXHAUST PIPE ASSEMBLY

  1. A170125
    Remove the 2 bolts and 2 compression springs.

  1. Disconnect the 3 exhaust pipe supports and remove the center exhaust pipe assembly.

  1. Remove the gasket from the No. 3 exhaust pipe sub-assembly.


7. REMOVE FRONT NO. 3 EXHAUST PIPE SUB-ASSEMBLY

  1. A171743
    Remove the 3 clamps and disconnect the heated oxygen sensor (for bank 1 sensor 2) connector.

  1. A170126
    Remove the 2 bolts, 2 nuts and front No. 3 exhaust pipe sub-assembly.

  1. Remove the 2 gaskets from the front No. 3 exhaust pipe sub-assembly.


8. REMOVE HEATED OXYGEN SENSOR (for Bank 1 Sensor 2)

  1. A172497E01
    Using SST, remove the heated oxygen sensor from the front No. 3 exhaust pipe sub-assembly.
    SST
    09224-00010  


9. REMOVE FRONT EXHAUST PIPE ASSEMBLY

  1. A171745
    Disconnect the heated oxygen sensor (for bank 2 sensor 2) connector.

  1. A170127
    Loosen the bolt.

  1. Remove the 2 nuts and front exhaust pipe assembly.

  1. Remove the gasket from the front exhaust pipe assembly.


10. REMOVE HEATED OXYGEN SENSOR (for Bank 2 Sensor 2)

  1. A172498E01
    Using SST, remove the heated oxygen sensor from the front exhaust pipe assembly.
    SST
    09224-00010  

← REMOVAL (May 2007 – Jul 2008)REMOVAL (from Jul 2010) →