2007-2013 Highlander Kluger · Service Manual BODY ELECTRICAL

ON-VEHICLE INSPECTION

Inspection · Vehicles built from May 2007


INSPECT FRONT FOG LIGHT RELAY

  1. B060778E86
    Remove the front fog light relay from the center relay block.

  1. Measure the resistance according to the value(s) in the table below.

    Standard resistance:
    Tester Connection
    Condition
    Specified Condition
    3 - 5
    Voltage is not applied between terminals 1 and 2
    10 kΩ or higher
    3 - 5
    Apply battery voltage between terminals 1 and 2
    Below 1 Ω

    If the result is not as specified, replace the front fog light relay.


INSPECT REAR FOG LIGHT RELAY

  1. B060778E86
    Remove the rear fog light relay from the center relay block.

  1. Measure the resistance according to the value(s) in the table below.

    Standard resistance:
    Tester Connection
    Condition
    Specified Condition
    3 - 5
    Voltage is not applied between terminals 1 and 2
    10 kΩ or higher
    3 - 5
    Apply battery voltage between terminals 1 and 2
    Below 1 Ω

    If the result is not as specified, replace the rear fog light relay.

← ON-VEHICLE INSPECTION (from May 2007)ON-VEHICLE INSPECTION (from May 2007) →