2007-2013 Highlander Kluger · Service Manual BODY ELECTRICAL

ON-VEHICLE INSPECTION

Inspection · Vehicles built from May 2007


INSPECT TAILLIGHT RELAY

  1. A087121E11
    Remove the taillight relay from the instrument panel junction block.

  1. Measure the resistance according to the value(s) in the table below.

    Standard resistance:
    Tester Connection
    Specified Condition
    3 - 5
    10 kΩ or higher
    Below 1 Ω (When battery voltage is applied to terminals 1 and 2)
    3 - 4
    Below 1 Ω
    10 kΩ or higher (When battery voltage is applied to terminals 1 and 2)

    If the result is not as specified, replace the taillight relay.

← INSTALLATION (from Jul 2010)ON-VEHICLE INSPECTION (from May 2007) →