B1441/41 Air Mix Damper Control Servo Motor Circuit (Passenger Side)
Diagnostic trouble codes · Vehicles built May 2007 – Jul 2008
Versions by build date: May 2007 – Jul 2008 Aug 2008 – Jun 2010 from Jul 2010
DESCRIPTION
The air mix damper servo sends pulse signals to indicate the damper position to the air conditioning amplifier. The air conditioning amplifier activates the motor (normal or reverse) based on these signals to move the air mix damper (passenger seat) to the appropriate position. This adjusts the amount of air passing through the heater core after passing the evaporator and controls the temperature of the blown air.- HINT:
- Confirm that there are no mechanical problems because this DTC can be set if either a damper link or damper is mechanically locked.
| DTC No. |
DTC Detection Condition |
Trouble Area |
| B1441/41 |
Air mix damper position does not change even if air conditioning amplifier operates air mix damper control servo motor |
|
WIRING DIAGRAM


INSPECTION PROCEDURE
| 1. READ VALUE USING INTELLIGENT TESTER (AIR MIX PULSE-P) |
Connect the intelligent tester to the DLC3.
Turn the ignition switch on (IG) and turn the intelligent tester main switch on.
Select the items below in the Data List, and read the value displayed on the intelligent tester.
Data List / Air Conditioner: Tester Display
Measurement Item/Range
Normal Condition
Diagnostic Note
Air Mix Pulse-P
Passenger side air mix servo motor target pulse /
Min.: 0, Max.: 255
- LHD:
MAX COLD: 105 (pulse)
MAX HOT: 7 (pulse)
- RHD:
MAX COLD: 5 (pulse)
MAX HOT: 103 (pulse)
-
- OK:
- The display is as specified in the normal condition column.
- Result:
Result
Proceed to
NG
A
OK (Checking from PROBLEM SYMPTOMS TABLE)
B
OK (Checking from DTC)
C
- LHD:
|
|
||||
|
|
||||
| A | |
| 2. REPLACE AIR MIX CONTROL SERVO MOTOR |
Replace air mix control servo motor (Click here).
| NEXT | |
| 3. CHECK DTC OUTPUT |
Check for DTC.
- OK:
- DTC B1441/41 is not output.
|
|
||||
| OK | ||
| ||
