2007-2013 Highlander Kluger · Service Manual HEATER & AIR CONDITIONING SYSTEM

B1441/41 Air Mix Damper Control Servo Motor Circuit (Passenger Side)

Diagnostic trouble codes · Vehicles built Aug 2008 – Jun 2010

Versions by build date: May 2007 – Jul 2008 Aug 2008 – Jun 2010 from Jul 2010

DESCRIPTION

The air mix damper servo sends pulse signals to indicate the damper position to the air conditioning amplifier. The air conditioning amplifier activates the motor (normal or reverse) based on these signals to move the air mix damper (passenger seat) to the appropriate position. This adjusts the amount of air passing through the heater core after passing the evaporator and controls the temperature of the blown air.

HINT:
Confirm that there are no mechanical problems because this DTC can be set if either a damper link or damper is mechanically locked.

DTC No.
DTC Detection Condition
Trouble Area
B1441/41
Air mix damper position does not change even if air conditioning amplifier operates air mix damper control servo motor
  1. Air mix control servo motor
  2. Air conditioning harness
  3. Air conditioning amplifier

WIRING DIAGRAM

E133419E05

INSPECTION PROCEDURE


1. READ VALUE USING INTELLIGENT TESTER (AIR MIX PULSE-P)
  1. Connect the intelligent tester to the DLC3.

  1. Turn the ignition switch on (IG) and turn the intelligent tester main switch on.

  1. Select the items below in the Data List, and read the value displayed on the intelligent tester.

    Data List / Air Conditioner: 
    Tester Display
    Measurement Item/Range
    Normal Condition
    Diagnostic Note
    Air Mix Pulse-P
    Passenger side air mix servo motor target pulse /
    Min.: 0, Max.: 255
    1. LHD:
      MAX COLD: 105 (pulse)
      MAX HOT: 7 (pulse)
    1. RHD:
      MAX COLD: 5 (pulse)
      MAX HOT: 103 (pulse)
    -

    OK:
    The display is as specified in the normal condition column.


    Result:
    Result
    Proceed to
    NG
    A
    OK (Checking from PROBLEM SYMPTOMS TABLE)
    B
    OK (Checking from DTC)
    C



B
PROCEED TO NEXT CIRCUIT INSPECTION SHOWN IN PROBLEM SYMPTOMS TABLE (Click here)

C
REPLACE AIR CONDITIONING AMPLIFIER
A


2. REPLACE AIR MIX CONTROL SERVO MOTOR
  1. Replace air mix control servo motor (Click here).


NEXT


3. CHECK DTC OUTPUT
  1. Check for DTC.

    OK:
    DTC B1441/41 is not output.



NG
REPAIR OR REPLACE AIR CONDITIONING HARNESS
OK

END


← B1441/41 Air Mix Damper Control Servo Motor Circuit (Passenger Side) (May 2007 – Jul 2008)B1441/41 Air Mix Damper Control Servo Motor Circuit (Passenger Side) (from Jul 2010) →