2007-2013 Highlander Kluger · Service Manual BODY ELECTRICAL

Sound Signal Circuit between Multi-media Interface ECU and Stereo Jack Adapter

Circuit diagnosis · Vehicles built from Jul 2010

DESCRIPTION

The No. 1 stereo jack adapter assembly sends the sound data from an external device to the multi-media interface ECU through this circuit.

WIRING DIAGRAM

E213359E02

INSPECTION PROCEDURE


1. CHECK HARNESS AND CONNECTOR

  1. E210106E06
    Disconnect the multi-media interface ECU connector.

  1. E210105E13
    Disconnect the No. 1 stereo jack adapter assembly connector.

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    E27-3 (UDO+) - E28-2 (UDI+)
    Always
    Below 1 Ω
    E27-2 (UDO-) - E28-3 (UDI-)
    Always
    Below 1 Ω
    E27-5 (UJSS) - E28-5 (UESS)
    Always
    Below 1 Ω
    E27-3 (UDO+) - Body ground
    Always
    10 kΩ or higher
    E27-2 (UDO-) - Body ground
    Always
    10 kΩ or higher
    E27-5 (UJSS) - Body ground
    Always
    10 kΩ or higher

    Text in Illustration 
    *a
    Front view of wire harness connector
    (to Multi-media Interface ECU)
    *b
    Front view of wire harness connector
    (to No. 1 Stereo Jack Adapter Assembly)



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK

PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE (Click here)


← Sound Signal Circuit between Radio Receiver and Stereo Jack Adapter (from Jul 2010)Mute Signal Circuit between Radio Receiver and Multi-media Interface ECU (from Jul 2010) →