2007-2013 Highlander Kluger · Service Manual BODY ELECTRICAL

Mute Signal Circuit between Radio Receiver and Multi-media Interface ECU

Circuit diagnosis · Vehicles built from Jul 2010

DESCRIPTION

The multi-media interface ECU sends a mute signal to the radio receiver.
The radio receiver controls the volume according to the mute signal from the multi-media interface ECU.
The mute signal is sent to reduce noise and popping sounds generated when switching modes.
If there is an open in the circuit, noise can be heard from the speakers when changing the sound source.
If there is a short in the circuit, even though the radio receiver is functioning, no sound, or only an extremely faint sound, can be heard.

WIRING DIAGRAM

E175068E64

INSPECTION PROCEDURE


1. INSPECT RADIO RECEIVER

  1. E152226E61
    Measure the voltage according to the value(s) in the table below.

    Standard Voltage:
    Tester Connection
    Condition
    Specified Condition
    E24-6 (MUTE) - Body ground
    Ignition switch ACC, USB audio system is playing → Changing modes
    Above 3.5 V → Below 1 V

    Text in Illustration 
    *a
    Component with harness connected
    (Radio Receiver)



NG
Go to step 2
OK

PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE (Click here)

2. CHECK HARNESS AND CONNECTOR (RADIO RECEIVER - MULTI-MEDIA INTERFACE ECU)
  1. Disconnect the radio receiver and multi-media interface ECU connectors.

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    E24-6 (MUTE) - E25-6 (MUT1)
    Always
    Below 1 Ω
    E24-6 (MUTE) - Body ground
    Always
    10 kΩ or higher



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK


3. INSPECT MULTI-MEDIA INTERFACE ECU

  1. E152226E62
    Reconnect the multi-media interface ECU connector.

  1. Measure the voltage according to the value(s) in the table below.

    Standard Voltage:
    Tester Connection
    Condition
    Specified Condition
    E25-6 (MUT1) - Body ground
    Ignition switch ACC
    Above 3.5 V

    Text in Illustration 
    *a
    Component with harness connected
    (Multi-media Interface ECU)



NG
REPLACE MULTI-MEDIA INTERFACE ECU (Click here)
OK

REPLACE RADIO RECEIVER (Click here)


← Sound Signal Circuit between Multi-media Interface ECU and Stereo Jack Adapter (from Jul 2010)AVC-LAN Circuit (from Jul 2010) →