2007-2013 Highlander Kluger · Service Manual BODY ELECTRICAL

Sound Signal Circuit between Multi-media Interface ECU and Stereo Jack Adapter

Circuit diagnosis · Vehicles built from Jul 2010

DESCRIPTION

The No. 1 stereo jack adapter assembly sends an external device sound signal to the multi-media interface ECU via this circuit.
The sound signal that has been sent is amplified by the stereo component amplifier assembly, and then is sent to the speakers.
If there is an open or short in the circuit, sound cannot be heard from the speakers even if there is no malfunction in the stereo component amplifier assembly, navigation receiver assembly or speakers.

WIRING DIAGRAM

E210050E03

INSPECTION PROCEDURE


1. CHECK HARNESS AND CONNECTOR (MULTI-MEDIA INTERFACE ECU - NO. 1 STEREO JACK ADAPTER)

  1. E210106E09
    Disconnect the E28 multi-media interface ECU connector.

  1. E210105E20
    Disconnect the E27 No. 1 stereo jack adapter assembly connector.

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    E27-3 (UDO+) - E28-2 (UDI+)
    Always
    Below 1 Ω
    E27-2 (UDO-) - E28-3 (UDI-)
    Always
    Below 1 Ω
    E27-5 (UJSS) - E28-5 (UESS)
    Always
    Below 1 Ω
    E27-3 (UDO+) - Body ground
    Always
    10 kΩ or higher
    E27-2 (UDO-) - Body ground
    Always
    10 kΩ or higher
    E27-5 (UJSS) - Body ground
    Always
    10 kΩ or higher

    Text in Illustration 
    *a
    Front view of wire harness connector
    (to Multi-media Interface ECU)
    *b
    Front view of wire harness connector
    (to No. 1 Stereo Jack Adapter Assembly)



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK

PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE (Click here)


← Sound Signal Circuit between Navigation Receiver Assembly and Stereo Jack Adapter (from Jul 2010)AVC-LAN Circuit (from Jul 2010) →