2007-2013 Highlander Kluger · Service Manual BODY ELECTRICAL

AVC-LAN Circuit

Circuit diagnosis · Vehicles built from Jul 2010

DESCRIPTION

Each unit of the navigation system connected to the AVC-LAN (communication bus) transfers the switch signals using the AVC-LAN.
If a short to +B or short to ground occurs in the AVC-LAN, the navigation system will not function normally because communication is not possible.

INSPECTION PROCEDURE

NOTICE:
The navigation receiver assembly is the master unit.


1. INSPECT NAVIGATION RECEIVER ASSEMBLY

  1. E168554E13
    Disconnect the E23 navigation receiver assembly connector.

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    E23-9 (TXM+) - E23-10 (TXM-)
    Always
    60 to 80 Ω

Text in Illustration 
*a
Component without harness connected
(Navigation Receiver Assembly)


NG
REPLACE NAVIGATION RECEIVER ASSEMBLY (Click here)
OK


2. CHECK HARNESS AND CONNECTOR (AVC-LAN CIRCUIT)

HINT:
For details of the connectors, refer to Terminals of ECU (Click here).

  1. Referring to the AVC-LAN wiring diagram below, check all AVC-LAN circuits.

    1. Disconnect all connectors in all AVC-LAN circuits.

    2. Check for an open or short in all AVC-LAN circuits.E187098E06

      OK:
      There is no open or short circuit.



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK


3. INSPECT MALFUNCTIONING PARTS
  1. Disconnect and reconnect each slave unit one by one until the master unit returns to normal operation.

    HINT:
    1. Check all slave units.
    2. If disconnecting a slave unit causes the master unit to return to normal operation, the slave unit is defective and should be replaced.

    OK:
    Master unit returns to normal operation.



NG
REPLACE NAVIGATION RECEIVER ASSEMBLY (Click here)
OK

REPLACE MALFUNCTIONING PARTS


← Sound Signal Circuit between Multi-media Interface ECU and Stereo Jack Adapter (from Jul 2010)Reverse Signal Circuit (from Jul 2010) →