2007-2013 Highlander Kluger · Service Manual BODY ELECTRICAL

Sound Signal Circuit between Navigation Receiver Assembly and Multi-media Interface ECU

Circuit diagnosis · Vehicles built from Jul 2010

DESCRIPTION

The multi-media interface ECU sends USB audio sound signals to the navigation receiver assembly via this circuit.
The sound signal that has been sent is amplified by the navigation receiver assembly, and then is sent to the speakers.
If there is an open or short in the circuit, sound cannot be heard from the speakers even if there is no malfunction in the navigation receiver assembly or speakers.

WIRING DIAGRAM

E210052E04

INSPECTION PROCEDURE


1. CHECK HARNESS AND CONNECTOR (NAVIGATION RECEIVER ASSEMBLY - MULTI-MEDIA INTERFACE ECU)
  1. Disconnect the E23 navigation receiver assembly connector.

  1. Disconnect the E25 multi-media interface ECU connector.

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    E23-1 (CSLD) - E25-1 (USD1)
    Always
    Below 1 Ω
    E23-2 (CDR+) - E25-2 (URO+)
    Always
    Below 1 Ω
    E23-3 (CDR-) - E25-3 (URO-)
    Always
    Below 1 Ω
    E23-4 (CDL+) - E25-4 (ULO+)
    Always
    Below 1 Ω
    E23-5 (CDL-) - E25-5 (ULO-)
    Always
    Below 1 Ω
    E23-2 (CDR+) - Body ground
    Always
    10 kΩ or higher
    E23-3 (CDR-) - Body ground
    Always
    10 kΩ or higher
    E23-4 (CDL+) - Body ground
    Always
    10 kΩ or higher
    E23-5 (CDL-) - Body ground
    Always
    10 kΩ or higher
    E23-1 (CSLD) - Body ground
    Always
    10 kΩ or higher



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK

PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE (Click here)


← Speaker Circuit (from Jul 2010)Sound Signal Circuit between Navigation Receiver Assembly and Stereo Jack Adapter (from Jul 2010) →