2007-2013 Highlander Kluger · Service Manual BODY ELECTRICAL

Black Screen

Circuit diagnosis · Vehicles built Aug 2008 – Jun 2010

Versions by build date: May 2007 – Jul 2008 Aug 2008 – Jun 2010 from Jul 2010

INSPECTION PROCEDURE


1. CHECK DISPLAY SETTING
  1. Check that the display is not in "Screen OFF" mode.

    OK:
    The display setting is not in "Screen OFF" mode.



NG
CHANGE SCREEN TO "SCREEN ON" MODE
OK


2. CHECK IMAGE QUALITY SETTING
  1. Check that the screen color quality can be set.

    OK:
    Setting is possible.



NG
Go to step 3
OK

PRESS PANEL SWITCH "DISPLAY" AND SET SCREEN COLOR QUALITY TO NORMAL

3. CHECK CABIN
  1. Check that condensation is not likely to occur in the cabin, and that the temperature is not high or extremely low in the cabin.

    HINT:
    1. A humid cabin and a rapid change in temperature may lead to condensation. Condensation in the cabin may cause a short circuit.
    2. The appropriate cabin temperature is 20 to 30°C (68 to 86°F).

    OK:
    Condensation is not likely being produced and the temperature is not high or extremely low.



NG
SET CABIN TO APPROPRIATE TEMPERATURE
OK

PROCEED TO NEXT CIRCUIT INSPECTION SHOWN IN PROBLEM SYMPTOMS TABLE (Click here)


← Black Screen (May 2007 – Jul 2008)Black Screen (from Jul 2010) →