2007-2013 Highlander Kluger · Service Manual STEERING

C1552 PIG Power Supply Voltage Malfunction

Diagnostic trouble codes · Vehicles built Aug 2008 – Jun 2010

Versions by build date: May 2007 – Jul 2008 Aug 2008 – Jun 2010 from Jul 2010

DESCRIPTION

When a problem occurs in the power steering system, the power source relay circuit is shut off to stop the power assist.
DTC No.
DTC Detection Condition
Trouble Area
C1552
PIG power source circuit malfunction inside ECU
  1. PIG power source circuit
  2. Power steering ECU

WIRING DIAGRAM

C160852E04

INSPECTION PROCEDURE


1. READ VALUE USING INTELLIGENT TESTER (PIG POWER SUPPLY)
  1. Turn the ignition switch off.

  1. Connect the intelligent tester to the DLC3.

  1. Turn the ignition switch on (IG).

  1. Turn the intelligent tester on.

  1. Enter the following menus: Chassis / EMPS / Data List.

  1. Select the item "PIG Power Supply" in the Data List and read the value displayed on the intelligent tester.

    EMPS: 
    Tester Display
    Measurement Item/Range
    Normal Condition
    Diagnostic Note
    PIG Power Supply
    PIG power supply:
    Min.: 0 V
    Max.: 20.1531 V
    11 to 14 V
    Power steering is in operation

OK:
The normal condition value is displayed on the intelligent tester.



NG
Go to step 2
OK

CHECK INTERMITTENT PROBLEMS

2. CHECK HARNESS AND CONNECTOR (POWER STEERING ECU - BATTERY AND BODY GROUND)

  1. C113534E08
    Disconnect the connector from the power steering ECU.

  1. Measure the voltage according to the value(s) in the table below.

    Standard voltage:
    Tester Connection
    Switch Condition
    Specified Condition
    D4-1 (PIG) - Body ground
    Ignition switch on (IG)
    11 to 14 V

  1. Measure the resistance according to the value(s) in the table below.

    Standard resistance:
    Tester Connection
    Condition
    Specified Condition
    D4-2 (PGND) - Body ground
    Always
    Below 1 Ω



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK

REPLACE POWER STEERING ECU (Click here)


← C1552 PIG Power Supply Voltage Malfunction (May 2007 – Jul 2008)C1552 PIG Power Supply Voltage Malfunction (from Jul 2010) →