When the back door entry lock and unlock functions do not operate, one of the following may be malfunctioning: 1) power door lock control system, or 2) outside electrical key oscillator (back door), or 3) main body ECU (instrument panel junction block), or 4) certification ECU (smart key ECU assembly).
WIRING DIAGRAM
INSPECTION PROCEDURE
NOTICE:
Before performing the inspection, check that there are no problems related to "CAN COMMUNICATION SYSTEM" and "LIN COMMUNICATION SYSTEM".
1. CHECK POWER DOOR LOCK OPERATION
When the door control switch on the master switch assembly is operated, check that the locked doors unlock (Click here).
Bring the electrical key transmitter near the outside electrical key oscillator (back door), and perform an entry back door open and entry lock functions check.
NOTICE:
If the key is brought within 0.2 m (0.656 ft.) of the rear bumper, communication is not possible.
HINT:
When the electrical key transmitter is brought near the electrical key antenna, the possibility of wave interference decreases, and it can be determined if wave interference is causing the problem symptom.
If the operation check is normal, the possibility of wave interference is high. Also, added vehicle components may cause wave interference. If installed, remove them and perform the operation.
Enter the following menus:Body / Entry & Start / Key Communication Check / Overhead + Back Door.
When the electrical key transmitter is held at the same height as the rear bumper upper surface and aligned with the center of the rear of the vehicle, check that the wireless door lock buzzer sounds.
HINT:
If the buzzer sounds, it can be determined that the back door outside electrical key oscillator is operating normally.