INSTALLATION
Removal / installation · Vehicles built from Jul 2010
Versions by build date: May 2007 – Jul 2008 Aug 2008 – Jun 2010 from Jul 2010
| 1.
INSTALL ENGINE REAR OIL SEAL |
 |
- Apply MP grease to a new oil seal lip.
Using SST and a hammer, tap in the oil seal.
- SST
- 09223-15030
09950-70010
(09951-07150)
- Oil seal tap in depth:
- -0.5 to 0.5 mm (-0.020 to 0.020 in.)
| 2.
INSTALL DRIVE PLATE AND RING GEAR SUB-ASSEMBLY |
 |
- Using SST, hold the crankshaft.
- SST
- 09213-70011
(09213-70020)
09330-00021
- Apply adhesive to 2 or 3 threads of the mounting bolt end.
- Adhesive:
- Toyota Genuine Adhesive 1324, Three Bond 1324 or equivalent
- Install the front spacer, drive plate and rear spacer on the crankshaft.
Install and tighten the 8 mounting bolts uniformly in several steps.
-
Torque:
- 83 N*m{
850 kgf*cm
, 61 ft.*lbf
}
| 3.
INSTALL AUTOMATIC TRANSAXLE ASSEMBLY (for 2WD) |
 |
- HINT:
-
Click here.
| 4.
INSTALL AUTOMATIC TRANSAXLE ASSEMBLY (for 4WD) |
 |
- HINT:
-
Click here.