2007-2013 Highlander Kluger · Service Manual ENGINE

INSTALLATION

Removal / installation · Vehicles built May 2007 – Jul 2008

Versions by build date: May 2007 – Jul 2008 Aug 2008 – Jun 2010 from Jul 2010


1. INSTALL ENGINE REAR OIL SEAL

  1. A132245E01
    Apply MP grease to a new oil seal lip.

  1. Using SST and a hammer, tap in the oil seal.

    SST
    09223-15030  
    09950-70010   (09951-07150)

    Oil seal tap in depth:
    -0.5 to 0.5 mm (-0.020 to 0.020 in.)


2. INSTALL DRIVE PLATE AND RING GEAR SUB-ASSEMBLY

  1. A129631E01
    Using SST, hold the crankshaft.
    SST
    09213-70011   (09213-70020)
    09330-00021  

  1. P000601E04
    Apply adhesive to 2 or 3 threads of the mounting bolt end.

    Adhesive:
    Toyota Genuine Adhesive 1324, Three Bond 1324 or equivalent


    1. A132243E01
      Install the front spacer, drive plate and rear spacer on the crankshaft.

    2. Install and tighten the 8 mounting bolts uniformly in several steps.

      Torque:
      83 N*m{ 850 kgf*cm , 61 ft.*lbf }


3. INSTALL AUTOMATIC TRANSAXLE ASSEMBLY (for 2WD)

HINT:
Click here.


4. INSTALL AUTOMATIC TRANSAXLE ASSEMBLY (for 4WD)

HINT:
Click here.

← REMOVAL (from Jul 2010)INSTALLATION (Aug 2008 – Jun 2010) →