2007-2013 Highlander Kluger · Service Manual ENGINE

REMOVAL

Removal / installation · Vehicles built from Jul 2010

Versions by build date: May 2007 – Jul 2008 Aug 2008 – Jun 2010 from Jul 2010


1. REMOVE AUTOMATIC TRANSAXLE ASSEMBLY (for 2WD)

HINT:
Click here.


2. REMOVE AUTOMATIC TRANSAXLE ASSEMBLY (for 4WD)

HINT:
Click here.


3. REMOVE DRIVE PLATE AND RING GEAR SUB-ASSEMBLY

  1. A129631E01
    Using SST, hold the crankshaft.
    SST
    09213-70011   (09213-70020)
    09330-00021  

  1. A132243
    Remove the 8 bolts, front spacer, drive plate and rear spacer.


4. REMOVE ENGINE REAR OIL SEAL

  1. A132244E02
    Using a knife, cut off the oil seal lip.

  1. Using a screwdriver, pry out the oil seal.

    NOTICE:
    Be careful not to damage the crankshaft. Tape the screwdriver tip before use.

← REMOVAL (Aug 2008 – Jun 2010)INSTALLATION (May 2007 – Jul 2008) →