2007-2013 Highlander Kluger · Service Manual ENGINE

P0604 Internal Control Module Random Access Memory (RAM) Error

Diagnostic trouble codes · Vehicles built May 2007 – Jun 2010

Also covers:

Versions by build date: May 2007 – Jun 2010 from Jul 2010

DESCRIPTION

The ECM continuously monitors its own internal memory status, internal circuits, and output signals transmitted to the throttle actuator. This self-check ensures that the ECM is functioning properly. If any malfunction is detected, the ECM sets the appropriate DTC and illuminates the MIL.
The ECM memory status is diagnosed by internal mirroring of the main CPU and the sub CPU to detect random access memory errors. The two CPUs also perform continuous mutual monitoring. The ECM illuminates the MIL and sets a DTC if: 1) outputs from the two CPUs are different or deviate from the standards, 2) the signals sent to the throttle actuator deviate from the standards, 3) a malfunction is found in the throttle actuator supply voltage, and 4) any other ECM malfunction is found.
DTC No.
DTC Detection Condition
Trouble Area
P0604
P0606
P0607
P0657
ECM internal error (1 trip detection logic)
ECM

INSPECTION PROCEDURE

HINT:
Read freeze frame data using the intelligent tester. The ECM records vehicle and driving condition information as freeze frame data the moment a DTC is stored. When troubleshooting, freeze frame data can be helpful in determining whether the vehicle was running or stopped, whether the engine was warmed up or not, whether the air fuel ratio was lean or rich, as well as other data recorded at the time of a malfunction.


1. REPLACE ECM
  1. Replace the ECM (Click here).


NEXT

END


← P0560 System Voltage (from Jul 2010)P0604 Internal Control Module Random Access Memory (RAM) Error (+ 7 more codes) (from Jul 2010) →