2007-2013 Highlander Kluger · Service Manual ENGINE

P0560 System Voltage

Diagnostic trouble codes · Vehicles built from Jul 2010

Versions by build date: May 2007 – Jul 2008 Aug 2008 – Jun 2010 from Jul 2010

MONITOR DESCRIPTION

The battery supplies electricity to the ECM even when the ignition switch is off. This power allows the ECM to store data such as DTC history, freeze frame data and fuel trim values. If the battery voltage falls below a minimum level, these memories are cleared and the ECM determines that there is a malfunction in the power supply circuit. When the engine is next started, the ECM illuminates the MIL and sets the DTC.
DTC No.
DTC Detection Condition
Trouble Area
P0560
Open in ECM back up power source circuit (1 trip detection logic)
  1. Open in back up power source circuit
  2. EFI No. 1 fuse
  3. ECM

HINT:
If DTC P0560 is set, the ECM does not store other DTCs.


WIRING DIAGRAM

A118508E43

INSPECTION PROCEDURE

NOTICE:
Inspect the fuses for circuits related to this system before performing the following inspection procedure.

HINT:
Read freeze frame data using the intelligent tester. The ECM records vehicle and driving condition information as freeze frame data the moment a DTC is stored. When troubleshooting, freeze frame data can be helpful in determining whether the vehicle was running or stopped, whether the engine was warmed up or not, whether the air fuel ratio was lean or rich, as well as other data recorded at the time of a malfunction.


1. INSPECT ECM (BATT VOLTAGE)

  1. A239777E21
    Measure the voltage according to the value(s) in the table below.

    Standard voltage:
    Tester Connection
    Condition
    Specified Condition
    D56-24 (BATT) - B48-12 (E1)
    Always
    11 to 14 V

    Text in Illustration 
    *a
    Component with harness connected
    (ECM)



NG
Go to step 2
OK

CHECK FOR INTERMITTENT PROBLEMS (Click here)

2. CHECK HARNESS AND CONNECTOR (ECM - EFI NO. 1 FUSE)
  1. Check the harness and the connector between the EFI No. 1 fuse and ECM.

    1. Remove the EFI No. 1 fuse from the engine room relay block.

    2. Disconnect the ECM connector.

    3. Measure the resistance according to the value(s) in the table below.

      Standard resistance:
      Check for open:
      Tester Connection
      Condition
      Specified Condition
      EFI No. 1 fuse (2) - D56-24 (BATT)
      Always
      Below 1 Ω
      Check for short:
      Tester Connection
      Condition
      Specified Condition
      EFI No. 1 fuse (2) or D56-24 (BATT) - Body ground
      Always
      10 kΩ or higher

    4. Reconnect the ECM connector.

    5. Reinstall the EFI No. 1 fuse.



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR (ECM - EFI NO. 1 FUSE)
OK

CHECK AND REPLACE ENGINE ROOM RELAY BLOCK


← P0560 System Voltage (Aug 2008 – Jun 2010)P0604 Internal Control Module Random Access Memory (RAM) Error (+ P0606, P0607, P0657) (May 2007 – Jun 2010) →