2007-2013 Highlander Kluger · Service Manual BODY

ON-VEHICLE INSPECTION

Inspection · Vehicles built from Jul 2010

Versions by build date: May 2007 – Jun 2010 from Jul 2010


CHECK WINDSHIELD DEICER SWITCH
  1. Disconnect the windshield deicer switch connector.

  1. B263251E02
    Measure the voltage according to the value(s) in the table below.

    Standard voltage:
    Tester Connection
    Condition
    Specified Condition
    3 (ILL+) - 2 (ILL-)
    Headlight dimmer switch OFF → ON
    Below 1 V → 11 to 14 V
    5 (D) - 4 (E)
    Ignition switch on (IG)
    11 to 14 V
    1 (IG) - 4 (E)
    Ignition switch on (IG)
    11 to 14 V

    Standard resistance:
    Tester Connection
    Condition
    Specified Condition
    2 (ILL-) - Body ground
    Always
    Below 1 Ω
    4 (E) - Body ground
    Always
    Below 1 Ω

  1. Reconnect the windshield deicer connector.

  1. B263252E02
    Measure the voltage according to the value(s) in the table below.

    Standard voltage:
    Tester Connection
    Condition
    Specified Condition
    5 (D) - 4 (E)
    Ignition switch on (IG), windshield deicer switch OFF → ON
    11 to 14 V → Below 1 V (after 15 + / - 3 minutes: 11 to 14 V)
    1 (IG) - 4 (E)
    Ignition switch on (IG), windshield deicer switch OFF → ON
    Below 1 V → 11 to 14 V

  1. B134593E01
    Check the ON/OFF indicator of the switch.

    1. Push the switch several times. Check that the ON/OFF indicator illuminates or turns off according to the switch operation.

  1. B134594E01
    Check the illumination area of the switch.

    1. Check that the ON/OFF indicator illuminates or turns off according to the switch operation.

← ON-VEHICLE INSPECTION (May 2007 – Jun 2010)ON-VEHICLE INSPECTION (from May 2007) →