ON-VEHICLE INSPECTION
Inspection · Vehicles built from May 2007
| INSPECT POWER WINDOW RELAY (Marking: PWR) |
![]() ![]() |
Remove the power window relay from the instrument panel junction block.
Measure the resistance of the relay.
If the result is not as specified, replace the relay.Standard resistance Tester Connection
Condition
Specified Condition
3 - 5
Voltage is not applied between terminals 1 and 2
10 kΩ or higher
3 - 5
Apply battery voltage between terminals 1 and 2
Below 1 Ω


