Clock Display Circuit
Circuit diagnosis · Vehicles built Aug 2008 – Jun 2010
Versions by build date: May 2007 – Jul 2008 Aug 2008 – Jun 2010 Jul 2010 – Jun 2012 from Jul 2012
DESCRIPTION
In this circuit, the clock assembly receives a DISP switch signal from the combination meter assembly using the direct line and a multi-information display signal from each ECU through the combination meter assembly using the direct line.- HINT:
- If the vehicle is equipped with the multi-information display, check this circuit.
- If a system has a malfunction a relevant ECU stores DTCs.
- If the vehicle is equipped with the multi-information display, check this circuit.
WIRING DIAGRAM


INSPECTION PROCEDURE
| 1. CHECK CAN COMMUNICATION SYSTEM |
Check if a CAN communication DTC is output (Click here).
- Result:
Result
Proceed to
CAN communication DTC is not output.
A
CAN communication DTC is output.
B
|
|
||||
| A | |
| 2. CHECK HARNESS AND CONNECTOR (CLOCK ASSEMBLY - COMBINATION METER) |
Disconnect the E9 and E1 connectors.

Measure the resistance according to the value(s) in the table below.
- Standard resistance:
Tester Connection
Condition
Specified Condition
E9-9 (CLK) - E1-36 (MCLK)
Always
Below 1 Ω
E9-10 (DATA) - E1-37 (MDAT)
Always
Below 1 Ω
E9-11 (SYNC) - E1-38 (SYNC)
Always
Below 1 Ω
E9-9 (CLK) - Body ground
Always
10 kΩ or higher
E9-10 (DATA) - Body ground
Always
10 kΩ or higher
E9-11 (SYNC) - Body ground
Always
10 kΩ or higher
E9-16 (SGND) - Body ground
Always
Below 1 Ω
|
|
||||
| OK | |
| 3. INSPECT COMBINATION METER ASSEMBLY |
Reconnect the E1 connector.

Measure the resistance according to the value(s) in the table below.
- Standard resistance:
Tester Connection
Condition
Specified Condition
E9-9 (CLK) - Body ground
Ignition switch on (IG)
Pulse generation
E9-10 (DATA) - Body ground
Ignition switch on (IG)
Pulse generation
E9-11 (SYNC) - Body ground
Ignition switch on (IG)
Pulse generation
|
|
||||
| OK | ||
| ||
