2007-2013 Highlander Kluger · Service Manual BODY ELECTRICAL

Clock Display Circuit

Circuit diagnosis · Vehicles built Jul 2010 – Jun 2012

Versions by build date: May 2007 – Jul 2008 Aug 2008 – Jun 2010 Jul 2010 – Jun 2012 from Jul 2012

DESCRIPTION

In this circuit, the clock assembly receives a DISP switch signal from the combination meter assembly using the direct line and a multi-information display signal from each ECU through the combination meter assembly using the direct line.

HINT:
  1. If the vehicle is equipped with the multi-information display, check this circuit.
  2. If a system has a malfunction a relevant ECU stores DTCs.


WIRING DIAGRAM

E152377E05

INSPECTION PROCEDURE


1. CHECK CAN COMMUNICATION SYSTEM
  1. Check if a CAN communication DTC is output (Click here).

    Result:
    Result
    Proceed to
    CAN communication DTC is not output.
    A
    CAN communication DTC is output.
    B



B
GO TO CAN COMMUNICATION SYSTEM (Click here)
A


2. CHECK HARNESS AND CONNECTOR (CLOCK ASSEMBLY - COMBINATION METER)

  1. E152378E09
    Disconnect the E9 and E1 connectors.

  1. Measure the resistance according to the value(s) in the table below.

    Standard resistance:
    Tester Connection
    Condition
    Specified Condition
    E9-9 (CLK) - E1-36 (MCLK)
    Always
    Below 1 Ω
    E9-10 (DATA) - E1-37 (MDAT)
    Always
    Below 1 Ω
    E9-11 (SYNC) - E1-38 (SYNC)
    Always
    Below 1 Ω
    E9-9 (CLK) - Body ground
    Always
    10 kΩ or higher
    E9-10 (DATA) - Body ground
    Always
    10 kΩ or higher
    E9-11 (SYNC) - Body ground
    Always
    10 kΩ or higher
    E9-16 (SGND) - Body ground
    Always
    Below 1 Ω



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK


3. INSPECT COMBINATION METER ASSEMBLY

  1. E146936E18
    Reconnect the E1 connector.

  1. Measure the resistance according to the value(s) in the table below.

    Standard resistance:
    Tester Connection
    Condition
    Specified Condition
    E9-9 (CLK) - Body ground
    Ignition switch on (IG)
    Pulse generation
    E9-10 (DATA) - Body ground
    Ignition switch on (IG)
    Pulse generation
    E9-11 (SYNC) - Body ground
    Ignition switch on (IG)
    Pulse generation



NG
REPLACE COMBINATION METER ASSEMBLY (Click here)
OK

REPLACE CLOCK ASSEMBLY (Click here)


← Clock Display Circuit (Aug 2008 – Jun 2010)Clock Display Circuit (from Jul 2012) →