DATA LIST / ACTIVE TEST
System information · Vehicles built from Jul 2010
Versions by build date: May 2007 – Jun 2010 from Jul 2010
| DATA LIST |
- HINT:
- Using the intelligent tester to read the Data List allows switch, sensor, actuator and other item values to be read without removing any parts. Reading the Data List early in troubleshooting is one way to save diagnostic time.
- NOTICE:
- In the table below, the values listed under "Normal Condition" are reference values. Do not depend solely on these reference values when deciding whether a part is faulty or not.
Connect the intelligent tester to the DLC3.
Turn the engine switch on (IG).
Enter the following menus: Body / MAIN BODY or Entry&Start / Data List.
Read the Data List according to the display on the tester.
MAIN BODY (Main body ECU): Tester Display
Measurement Item/Range
Normal Condition
Diagnostic Note
Wireless Control
Wireless door lock control function / ON or OFF
ON: Operating
OFF: Not operating
-
Hazard Answer Back
Hazard answer-back of wireless / ON or OFF
ON: Operating
OFF: Not operating
-
Open Door Warning
Open door warning / ON or OFF
ON: Operating
OFF: Not operating
-
Unlock 2 Operation
Unlock 2 Operation of wireless unlock / ON or OFF
ON: All doors unlock when UNLOCK switch pressed twice
OFF: All doors unlock when UNLOCK switch pressed once
-
Auto Lock Time
Automatic lock time / 120 s, 60 s or 30 s
120 s: 120 seconds
60 s: 60 seconds
30 s: 30 seconds
-
Wireless Buzzer Resp*
Wireless door lock buzzer response / ON or OFF
ON: Operating
OFF: Not operating
-
- HINT:
- *: for RHD
Entry&Start (Certification ECU (Smart Key ECU Assembly)): Tester Display
Measurement Item/Range
Normal Condition
Diagnostic Note
Panic Alarm Function*
Panic function / ON or OFF
ON: Operating
OFF: Not operating
-
- HINT:
- *: for RHD
| ACTIVE TEST |
- HINT:
- Using the intelligent tester to perform Active Test allows relay, VSV, actuator and other items to be operated without removing any parts. This non-intrusive functional inspection can be very useful because intermittent operation may be discovered before parts or wiring is disturbed. Performing the Active Test early in troubleshooting is one way to save diagnostic time. The Data List can be displayed during the Active Test.
Connect the intelligent tester to the DLC3.
Turn the engine switch on (IG).
Enter the following menus: Body / MAIN BODY or Entry&Start / Active Test.
Perform the Active Test according to the display on the tester.
MAIN BODY (Main body ECU): Tester Display
Test Part
Control Range
Diagnostic Note
Hazard
Turns the turn signal flasher relay
ON/OFF
Observe headlight and rear combination light for correct operation
Vehicle Horn*
Turns the vehicle horns
ON/OFF
-
Illuminated Entry System
Interior light and ignition key cylinder light (Interior light switch is in DOOR position and all doors are closed)
ON/OFF
-
Trunk and Back-Door Open
Turns the back door opener motor
ON/OFF
Observe back door
Entry&Start (Certification ECU (Smart Key ECU Assembly)): Tester Display
Test Part
Control Range
Diagnostic Note
Wireless Buzzer Operation*
Turns the wireless door lock buzzer
ON/OFF
-
- HINT:
- *: for RHD