U0230 Lost Communication with Rear Gate Module
Diagnostic trouble codes · Vehicles built from Jul 2012
Versions by build date: May 2007 – Jul 2008 Aug 2008 – Jun 2010 Jul 2010 – Jun 2012 from Jul 2012
DESCRIPTION
| DTC No. |
Symptom |
Trouble Area |
| U0230 |
No communication from back door ECU continues |
|
- HINT:
- For vehicles with power back door system only.
WIRING DIAGRAM


INSPECTION PROCEDURE
- NOTICE:
- Turn the ignition switch off before measuring the resistances of CAN bus main wires and CAN bus branch wires.
- After the ignition switch is turned off, check that the key reminder warning system and light reminder warning system are not in operation.
- Before measuring the resistance, leave the vehicle as is for at least 1 minute and do not operate the ignition switch, any other switches, or the doors. If any doors need to be opened in order to check the connectors, open the doors and leave them open.
- Turn the ignition switch off before measuring the resistances of CAN bus main wires and CAN bus branch wires.
- HINT:
- Operating the ignition switch, any other switches, or a door triggers related ECU and sensor communication on the CAN. This communication will cause the resistance value to change.
- Even after DTCs are cleared, if a DTC is stored again after driving the vehicle for a while, the malfunction may be occurring due to vibration of the vehicle. In such a case, wiggling the ECUs or wire harness while performing the inspection below will help determine the cause of the malfunction.
- Operating the ignition switch, any other switches, or a door triggers related ECU and sensor communication on the CAN. This communication will cause the resistance value to change.
| 1. CHECK FOR DTC |
Connect the intelligent tester to the DLC3.
Turn the ignition switch to ON.
Check for DTCs.
- HINT:
- If the CAN MS bus communication error DTC U1002 is output, troubleshooting for U1002 and check for malfunctions in the CAN MS bus.
- Result:
Result
Proceed to
DTC U1002 is not output
A
DTC U1002 is output
B
|
|
||||
| A | |
| 2. CHECK CAN BUS LINE FOR DISCONNECTION (BACK DOOR ECU BRANCH WIRE) |
Disconnect the back door ECU connector.
Measure the resistance according to the value(s) in the table below.

- Standard Resistance:
Tester Connection
Condition
Specified Condition
O14-6 (MPX1) - O14-5 (MPX2)
Ignition switch off
54 to 69 Ω
|
|
||||
| OK | |
| 3. CHECK WIRE HARNESS |
Disconnect the back door ECU connector.

Measure the resistance of the wire harness side connector.
- Standard Resistance:
Tester Connection
Condition
Specified Condition
O14-11 (GND) - Body ground
Always
Below 1 Ω
Measure the voltage of the wire harness side connector.
- Standard Voltage:
Tester Connection
Condition
Specified Condition
O14-12 (B) - Body ground
Always
10 to 14 V
O14-8 (IG) - Body ground
Ignition switch ON
10 to 14 V
|
|
||||
| OK | ||
| ||
