Television Camera ECU Communication Stop Mode
Circuit diagnosis · Vehicles built Aug 2008 – Jun 2010
Versions by build date: May 2007 – Jul 2008 Aug 2008 – Jun 2010
DESCRIPTION
| Detection Item |
Symptom |
Trouble Area |
| Television Camera ECU Communication Stop Mode |
Parking assist monitor is not displayed on "BUS CHECK" screen of intelligent tester |
|
WIRING DIAGRAM


INSPECTION PROCEDURE
- NOTICE:
- Turn the ignition switch off before measuring the resistances of CAN bus main wires and CAN bus branch wires.
- After the ignition switch is turned off, check that the key reminder warning system and light reminder warning system are not operating.
- Before measuring the resistance, leave the vehicle as is for at least 1 minute and do not operate the ignition switch, any other switches, or the doors. If any doors need to be opened in order to check the connectors, open the doors and leave them open.
- Turn the ignition switch off before measuring the resistances of CAN bus main wires and CAN bus branch wires.
- HINT:
- Operating the ignition switch, any other switches, or a door triggers related ECU and sensor communication on the CAN. This communication will cause the resistance value to change.
- Even after DTCs are cleared, if a DTC is stored again after driving the vehicle for a while, the malfunction may be occurring due to vibration of the vehicle. In such a case, wiggling the ECUs or wire harness while performing the inspection below will help determine the cause of the malfunction.
- Operating the ignition switch, any other switches, or a door triggers related ECU and sensor communication on the CAN. This communication will cause the resistance value to change.
| 1. CHECK CAN BUS LINE FOR DISCONNECTION (TELEVISION CAMERA ECU BRANCH WIRE) |
Disconnect the television camera ECU connector.

Measure the resistance according to the value(s) in the table below.
- Standard resistance:
Tester Connection
Condition
Specified Condition
N15-7 (CANH) - N15-6 (CANL)
Ignition switch off
54 to 69 Ω
|
|
||||
| OK | |
| 2. CHECK WIRE HARNESS (TELEVISION CAMERA ECU - BATTERY AND BODY GROUND) |
Disconnect the television camera ECU connector.

Measure the resistance according to the value(s) in the table below.
- Standard resistance:
Tester Connection
Condition
Specified Condition
N16-8 (GND1) - Body ground
Ignition switch off
Below 1 Ω
Measure the voltage according to the value(s) in the table below.
- Standard voltage:
Tester Connection
Condition
Specified Condition
N16-1 (+B) - Body ground
Always
10 to 14 V
N16-4 (ACC) - Body ground
Ignition switch on (ACC)
10 to 14 V
N16-3 (IG) - Body ground
Ignition switch on (IG)
10 to 14 V
|
|
||||
| OK | ||
| ||
